User manual

SIMB-M22 User Manual 28
2.8.14 Serial ATA Connector (SATA1, SATA2)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives.
SATA1
SATA2
Note! Connect the right-angle side of SATA signal cable to SATA device. Or
you may connect the right-angle side of SATA cable to the onboard
SATA port to avoid mechanical conflict with huge graphics cards.
Important!  Install the Windows® 2000 Service Pack 4 or the Windows® XP
Service Pack1 before using Serial ATA.
 When using the connectors in Standard IDE mode, connect the pri-
mary (boot) hard disk drive to the SATA1 connector.