User manual

3 Chapter 1
• USB Interface:
External:Four USB ports, USB EHCI, Rev. 2.0 compliant
Internal: One USB port, USB EHCI, Rev. 2.0 compliant
(Optional cable wiring: 2 x USB ports, USB EHCI, Rev 2.0 compliant)
• Compact Flash Slots: Two type I/II CompactFlash Slots, One internal and
one external
• HDD: SATA HDD extension kit for one standard 2.5" HDD
One external eSATA device (Does not support hot swap)
• LEDs: Power, Standby, HDD, 4 COM ports Tx /Rx,
LAN (Active, Status)
(Optional: 4x Programmable LED while COM ports Tx/Rx disable)
• PCI-bus Slot Power: 12 V @ 2A,
-12V @ 0.5 A,
5 V @ 4 A,
3.3 V @ 4 A
3.3 VSB @ 1.5A
Note: Total power total combined power consumption on the PCI slots
should be less than 20W
• Anti-Shock:
20 G @ Wall mounting, IEC 68 section 2-27, half sine, 11 ms w/HDD
50 G @ Wall mounting, IEC 68 section 2-27, half sine, 11 ms w/CF
• Anti-Vibration:
2 Grms w/CF@IEC 68 sec. 2-64, random, 5~500Hz, 1 Oct./min,1hr axis
1 Grms w/HDD@IEC 68 sec. 2-64, random, 5~500Hz, 1 Oct./min, 1hr axis
• Power Supply: 9 ~ 36 VDC
• Operating Temperature: -10 ~ 60° C (14 ~ 140° F)
Note: The temperature inside the chassis may be 5~10° C higher than the
ambient temperature. To ensure stable performance, please make sure the
operating temperature of the installed PCI add-on card is higher than 60° C.
• Relative Humidity: 5~95% @ 40° C (non-condensing)
• Power Consumption: 20 W (Typical)
• Power Requirement: 9 ~ 36 VDC (e.g +24 V @ 2 A) Min. 48 W
• Chassis Size (WxHxD): 157 x 238 x 177mm (6.2”x 9.3”x 7”)
• Mounting: Wall/Panel/Stand mounting
• Weight: 4.5 kg
• Software OS: WinXP Embedded/CE 6.0/2000/XP, Windows 7, Linux