User manual

19 Chapter 3

1. Detach the HDD bracket by unscrewing the four screws (#1) on the

top of the HDD bracket.

Figure 3.1: Detaching the HDD bracket

2. Place the HDD inside the HDD bracket and tighten the four screws

(#2) from both sides of the HDD bracket.

Figure 3.2: Placing the HDD inside the bracket

3. The HDD cable (1 x 44-pin to 1 x 44-pin) is located next to the

HDD bracket. Connect the HDD cable to the HDD. Make sure that

the red wire corresponds to Pin 1 on the connector, which is

labelled on the board. Plug the other end of the cable into the HDD,

with Pin 1 on the cable corresponding to Pin 1 on the HDD.

1935130602-M3x6L

1930030400-M3x4L

Screw

HDD (Bottom up)

Pin 1