User manual

21 Chapter 3

3. The IDE cable (1 x 44-pin to 1 x 44-pin) is located next to the CFC

adapter board. Connect the IDE cable to the CFC. Make sure that

the red wire corresponds to Pin 1 on the connector, which is labeled

on the board. Plug the other end of the cable into the CFC, with Pin

1 on the cable corresponding to Pin 1 on the CFC.

3.3 Placing the Rubber Seal

To ensure that the TREK-775/TREK-776 stays dry, the supplied rubber

seal must be placed correctly between the front bezel and the back cover.

Please note the direction of the seal: the flat, marked side should face up.

Figure 3.5: Placing the rubber seal

Marked

Flat (UP)