User`s manual

Chapter 2 System Setup 13
2.2 Installation Procedures
2.2.1 Connecting the power cord
The panel PC can only be powered by a DC electrical outlet
(16Vdc~25Vdc, 3.5A max.). Be sure to always handle the power cords
by holding the plug ends only. Please follow the figure 2-5 to connect
the male plug of the power cord to the DC inlet of the panel PC.
2.2.2 Connecting the keyboard or mouse
Before you start the computer, please connect the Y-shaped adaptor to
the PS/2 mouse and keyboard port on the I/O section of the panel PC,
then connect the necessary mouse or keyboard to the Y-shaped
adapter or serial ports.
2.2.3 Switching on the power
When you look at the right side of the panel PC, you will see the
power switch as shown in Figure 2-6 and Figure 2-7. When the switch
is on horizontal position as Figure 2-6, it is in lock status. You can set it
to avoid accidental open or close of the computer. When the switch is
on vertical position as Figure 2-7, it can be pushed to open or close the
computer.
Figure 2-5: Connect the power cord to DC inlet
DC inlet
AC/DC power
adapter (ref. photo)