User manual

ix Table of Contents
Table 2.25:32-bit Counter Control Bit ......................... 35
2.13 LED and Buzzer for System Diagnosis........................... 35
Table 2.26:LED & Buzzer Control Register ............... 35
Table 2.27:Programmable LED Control Bit ................ 36
Table 2.28:Programmable Buzzer Control Bit ............ 36
2.14 PC/104+........................................................................... 37
Figure 2.14:PC104+ Power Selection.......................... 37
Figure 2.15:CN14 Location ......................................... 37
Chapter 3 Initial Setup.................................................... 40
3.1 Configuration .................................................................. 40
3.2 Install a CompactFlash Card ........................................... 41
Figure 3.1:CompactFlash Card Slot Location ............. 41
3.3 Installing a USB Dongle ................................................. 42
Figure 3.2:CN3 Location of Internal USB Port ........... 42
3.4 Installing a Hard Disk ..................................................... 43
Figure 3.3:SATA Signal and Power Connector Location
44
3.5 Installation on Rack......................................................... 45
3.6 BIOS Setup and System Assignments ............................ 46
Appendix A System Settings & Pin Assignments ............ 48
A.1 System I/O Address & Interrupt Assignments................ 48
Table A.1: UNO-4672 System I/O Ports ...................... 48
A.2 RS-232/422/485 Serial Ports (COM1~COM10)............. 50
Table A.3:RS-232 Serial Ports COM1~2 ..................... 50
Table A.4:RS-232/422/485 Serial Ports (COM3~10) .. 51
A.3 USB Connectors (USB1~USB2) .................................... 52
Table A.5:USB Connector Pin Assignments................ 52
A.4 VGA Display Connector ................................................. 52
Table A.6:VGA Adaptor Cable Pin Assignments ........ 52
A.5 UNO-4672 Control Register ........................................... 53
Table A.7:UNO-4672 Control Register ....................... 53
Appendix B Watchdog Timer Programming................... 56
B.1 UNO-4672....................................................................... 56
Appendix C Enabling the Advantech 443 WDT.............. 60
C.1 Hardware Settings ........................................................... 60
Figure C.1:Location of CN45 and SW4 for Standard 443
WDT 60
Table C.1:CN45 and SW4 Descriptions ...................... 61
C.2 Software Operation ......................................................... 61