User manual

33 Chapter 3 Advantech M2M Utility
3.2.4 GPIO Setting Tab
The GPIO Setting Page enables you to define and get the GPIO directions
and values from/to VITA-350E remotely. There are 10 GPIO pins in
VITA-350E. Every GPIO pin could be set to input or output.
The GPIO Direction #n radio button in GPIOs Direction/Value group :
Specifies the direction of GPIO #n where n is from 1 to 10.
The GPIO Value #n combo-box in GPIOs Direction/Value group : Speci-
fies the output value of GPIO pin #n when the direction of the pin defined
to output.
The GPIO Status #n picture in GPIOs Status group : Shows the current
status of GPIO pin #n.
The Setup button in GPIOs Direction/Value group : Sets up directions
and values of the GPIO pins to VITA-350E.
The Get button in GPIOs Direction/Value group : Gets directions and val-
ues of GPIO pins from VITA-350E.
The Refresh button in the GPIOs Status group : Gets the values of GPIO
pins from VITA-350E.