User's Manual
Table Of Contents
- WISE-221X
- Contents
- 1 Product Overview
- 2 Product Specification
- 3 Mechanical and Hardware Installation
- 4 System Configuration
- 4.1 Connection
- 4.2 Configuring WISE-4210-AP with Browser
- 4.3 Install WISE Studio and Configure End Devices
- 4.4 Connection between AP and Nodes
- 4.5 Configure WISE-4210-AP
- 4.6 Setup WISE-221x Network
- 4.7 WISE-221x IO configuration
- 4.8 Access WISE-221x Data by Modbus/TCP Protocol
- 4.9 Push WISE-4210 data by RESTful Web Service
- 4.10 Access WISE-4210 I/O Data by RESTful API
WISE-221X User Manual 8
2.3.2 WISE-2211
1. Input power requirements:
WISE-2211 is a self-powered sensor node, power source is obtained from AI(Analog
input) which connected 4~20mA sensor transmitter. In other words, WISE-2211 mea-
sures data and gets power current from connected sensor transmitter.
2. Charging time
Test Condition:
Current input of WISE-2211: 4mA, direct current
2.4 Software
Utility: WISE Studio
WISE-4210-AP Protocols: TCP/IP, UDP, HTTP, HTTPS, DHCP, ARP, SNTP, MQTT,
Modbus/TCP, Modbus/RTU
WISE-4210-AP supports RESTful Web API .JSON format
2.5 Configuration Interface
WISE-221X
Interface: USB virtual COM port
Connector: Micro-B USB
USB chipset: Silicon Labs CP210x
Driver: CP210x USB to UART Bridge VCP Drivers (https://www.silabs.com/
products/development-tools/software/usb-to-uart-bridge-vcp-drivers)
Data rate TX power
Data Transmission
Time period
1st Charging Time
for WISE-2211
50Kbps 12 dBm 1s
90s
2.5Kbps
5 dBm 5s
12 dBm 10s
5K bps
5 dBm 5s
12 dBm 10s
625 bps 12 dBm 30 s