User's Manual
Table Of Contents
- WISE-221X
- Contents
- 1 Product Overview
- 2 Product Specification
- 3 Mechanical and Hardware Installation
- 4 System Configuration
- 4.1 Connection
- 4.2 Configuring WISE-4210-AP with Browser
- 4.3 Install WISE Studio and Configure End Devices
- 4.4 Connection between AP and Nodes
- 4.5 Configure WISE-4210-AP
- 4.6 Setup WISE-221x Network
- 4.7 WISE-221x IO configuration
- 4.8 Access WISE-221x Data by Modbus/TCP Protocol
- 4.9 Push WISE-4210 data by RESTful Web Service
- 4.10 Access WISE-4210 I/O Data by RESTful API
WISE-221X User Manual 20
4.1 Connection
1. Connect WISE-221X to your computer via a micro-B USB port. The USB driver
is required for creating a virtual COM port of a computer. Please refer to follow-
ing link to get the latest USB driver: CP210x USB to UART Bridge VCP Drivers
(https://www.silabs.com/products/development-tools/software/usb-to-uart-
bridge-vcp-drivers)
2. Connect WISE-4210-AP to your computer via the RJ-45 LAN port, and config-
ure the IP address of your computer as same IP domain as default IP address of
module:10.0.0.1
Figure 4.1 Connection WISE-221X and WISE-4210-AP
Note! Micro-B USB cable for configuring WISE-4210 nodes is available for
ordered:
1700023619-01 1M micro USB type-B male to USB type-A male
cable