User's Manual
Table Of Contents
- WISE-221X
- Contents
- 1 Product Overview
- 2 Product Specification
- 3 Mechanical and Hardware Installation
- 4 System Configuration
- 4.1 Connection
- 4.2 Configuring WISE-4210-AP with Browser
- 4.3 Install WISE Studio and Configure End Devices
- 4.4 Connection between AP and Nodes
- 4.5 Configure WISE-4210-AP
- 4.6 Setup WISE-221x Network
- 4.7 WISE-221x IO configuration
- 4.8 Access WISE-221x Data by Modbus/TCP Protocol
- 4.9 Push WISE-4210 data by RESTful Web Service
- 4.10 Access WISE-4210 I/O Data by RESTful API
27 WISE-221X User Manual
Chapter 4 System Configuration
4.6 Setup WISE-221x Network
After configuring all of end devices into the same network with WISE-4210-AP, users
can go to "End Devices" tab to check "End Device List".
MAC Address: The unique identifier of each end devices.
Modbus ID: Modbus ID is automatically assigned by WISE-4210-AP. User can
configure Modbus ID manually in "Configuration \ Modbus \ Modbus ID".
RSSI (dBm): Signal strength when data updated from end device to AP. RSSI-
will be updated after WISE-4210-AP received data from WISE-221x end node
devices. RSSI level higher than -100dBm is recommended.
Inactive Time: Elapsed time since last time WISE-4210-AP receives data from
an end node devices. If an end node device update data every 5 second and it
has good wireless signal quality, Inactive Time will show 0 or 1 every 5 seconds.
4.7 WISE-221x IO configuration
4.7.1 Date Update
Please go to "End Devices \ Date Update" to configure the data sample and update
interval, user can input update interval.