8 Port 10/100/1000Mbps Gigabit Switch Quick Installation Guide Model# ANS-800P
FCC Warning This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limitations are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
General Description Advantek Networks ANS-800P is a high-performance Gigabit Ethernet Switch with all 8 ports capable of 10, 100 and 1000Mbps auto-negotiation operation. The Gigabit switching hub supports Quality of Service (QoS), 8021Q and RMON counters. All ports support IEEE 802.1Q VLAN, Spanning Tree and isolated WAN vs. LAN firewall applications.
Front panel LED indicators After installing the switch, you can check its status from the LED indicators on the front panel shown below. Front View Rear panel ports Back Panel Ports 1x - 8x :The switch has eight 10/100/1000Mbps RJ-45 ports where you can connect computers or network devices to the switch. Power Connecting Plug the circle end of the power adapter firmly into the power port on the switch rear panel, and the other end into an electric service outlet, then the system is ready.
Uplink All Ports can be used as an uplink port for connecting to another unit without using crossover cable. When using the uplink port, you can extend the distance to 100m for linking another switch or hub. To prolong the operational life of your units *Never stack units more than eight high if freestanding *Do not place objects on top of any unit or stack *Do not obstruct any vents at the sides of the case *Use only the AC power adapter that came with the switch to prevent damage to the unit.