Wireless - N PCI Adapter Quick Installation Guide Model # AWN-11N-PCI
1. Introduction This is a Wireless PCI Adapter that delivers unrivaled wireless performance for your Desktop PC. It complies with IEEE 802.11n draft standard and backward compatible with IEEE 802.11b/g. This product is made in ISO9001 approved factory and complies with FCC part 15 regulations and CE approval. 1.1 Features • Complies with draft IEEE 802.11n standard • Up to 300Mbps data transfer rates in 802.11n mode • Backward compatible with IEEE 802.
2.3 Insert the Installation CD into CD-ROM drive then windows below will appear. Click “Install Driver & Utility” to begin device driver installation. 2.3.1 For Windows XP and 2000 Step1: Please read the following license agreement. Select I accept the terms of the license agreement and click Next to continue. Step1.1: In Windows XP, You can choose to configure the adapter through the Microsoft Zero Configuration Tool or the Ralink Configuration Tool.
Step1.2: If you need better performance, please choose Optimize for performance mode to enable Tx Burst mode. Or you can choose Optimize for WiFi mode to run in standard wireless network. Step2: Click Install to begin the installation. Step3: After the setup wizard has successfully installed wireless LAN, click Finish to exit the wizard. 2.3.2 For Windows Vista Step1: Please read the following license agreement. Select I accept the terms of the license agreement and click Next to continue.