User`s manual

Installation
-15-
1.2 Software Installation
There are no software drivers, patches or utilities installation needed, but only the configuration
setting.
Notice: It will take about 50 seconds to complete the boot up sequence after powered on the WLAN
Broadband Router; Power LED will be active, and after that the WLAN Activity LED will be flashing to
show the WLAN interface is enabled and working now.
1.3 Resetting the AP to Factory Default Settings
After you have tried other methods for troubleshooting your network, you may choose to Reset the
Access Point to the factory default settings.
To hard-reset the Access Point to Factory Default Settings,please do the following:
Notes: Device status:Power on
· Locate the Reset button on the back of the Access Point PCB
· press the Reset button
· Hold for about 5 seconds and then release
· After the Access Point reboots (this may take a few minutes) it will be reset to the factory default
settings.
2 Software configuration
Before Start to Configure
There are web based management and configuration functions allowing you to have the jobs done
easily.
The WLAN Broadband Router is delivered with the following factory default parameters on the
Ethernet LAN interfaces.
Default IP Address: 192.168.1.254
Default IP subnet mask: 255.255.255.0
WEB login User Name: <empty>
WEB login Password: <empty>