User`s manual
-16-
The device has three operation modes (Gateway/Bridge/WISP).
The default IP addresses for the device are 192.168.1.254, so you need to make sure the IP address
of your PC is in the same subnet as the device, such as 192.168.1.X.
2.1 Prepare your PC to configure the WLAN Broadband Router
For OS of Microsoft Windows 2000/ XP:
1.
Click the Start button and select Settings, then click Control Panel. The Control Panel window
will appear.
2.
Move mouse and double-click the right button on Network and Dial-up Connections icon. Move
mouse and double-click the Local Area Connection icon. The Local Area Connection window
will appear. Click Properties button in the Local Area Connection window.
3.
Check the installed list of Network Components. If TCP/IP is not installed, click the Add button
to install it; otherwise go to step 6.
4.
Select Protocol in the Network Component Type dialog box and click Add button.
5.
Select TCP/IP in Microsoft of Select Network Protocol dialog box then click OK button to install
the TCP/IP protocol, it may need the Microsoft Windows CD to complete the installation. Close
and go back to Network dialog box after the TCP/IP installation.
6.
Select TCP/IP and click the properties button on the Network dialog box.
7.
Select Specify an IP address and type in values as following example.
uIP Address: 192.168.1.1, any IP address within 192.168.1.1 to 192.168.1.253 is good to
connect the Wireless LAN Access Point.
uIP Subnet Mask: 255.255.255.0
8.
Click OK to completes the IP parameters setting.
For OS of Microsoft Windows Vista:
1.
Click the Start button and select Settings, then click Control Panel. The Control Panel window
will appear.
2.
Move mouse and double-click the right button on Network Connections item. The Network
Connections window will appear. Double click Local Area Connection icon, then User Account
Control window shown. Right click Continue button to set properties.
3.
In Local Area Connection Properties window, Choose Networking tab, move mouse and click
Internet Protocol Version 4 (TCP/IPv4), then click Properties button.
4.
Move mouse and click General tab, Select Specify an IP address and type in values as following
example.
uIP Address: 192.168.1.1, any IP address within 192.168.1.1 to 192.168.1.253 is good to
connect the Wireless LAN Access Point.
uIP Subnet Mask: 255.255.255.0
5.
Click OK to complete the IP parameters setting.
For OS of Microsoft Windows 95/ 98/ Me:
1.
Click the Start button and select Settings, then click Control Panel. The Control Panel window
will appear.
Note: Windows Me users may not see the Network control panel. If so, select View all
Control Panel options on the left side of the window
2.
Move mouse and double-click the right button on Network icon. The Network window will appear.
3.
Check the installed list of Network Components. If TCP/IP is not installed, click the Add button
to install it; otherwise go to step 6.
4.
Select Protocol in the Network Component Type dialog box and click Add button.
5.
Select TCP/IP in Microsoft of Select Network Protocol dialog box then click OK button to install
the TCP/IP protocol, it may need the Microsoft Windows CD to complete the installation. Close
and go back to Network dialog box after the TCP/IP installation.
6.
Select TCP/IP and click the properties button on the Network dialog box.
7.
Select Specify an IP address and type in values as following example.
uIP Address: 192.168.1.1, any IP address within 192.168.1.1 to 192.168.1.253 is good to