User's Manual

ADD-INS-PE3LR-CARE-ENG-31 Subject to change without noce
ADVEEZ, Bat MEAS - Impasse Jeanne Benozzi CS 83163 email: [e-mail]
31027 Toulouse Cedex 3 FRANCE Phoenix, AZ USA
[phone] [phone]
6
www.adveez.com
PE3LR / AD-CARE Controller specicaons / mounng instrucons
PE3LR-C / AD-CARE-C controller (FCC-ID : R8T-PE3LR-C*)
Stand alone door controller PE3LR-C / AD-CARE (health care variant)
Programming via PC
2 frequency RF system
Both ADVEEZ hands Free + 125 kHz EM cards supported
12V/24V power supply with no conguraon needed
200 mA average current draw / 1A peak
Operang temperature : -20°C / +70°C
Protecon class: IP54
Weight: 0.200 kg
10000 users
64000 event history
RS485 network—radio network opon (PE3LR-C-WL)
2 relays / 1 door contact switch
Mounng & Dimensions
Mounng (cauon: avoid mounng close to 125kHz proximity card
readers):
1) Fit all cables with terminal appropriate terminal blocks
according wiring details in page 3
2) Mount the back cover on the wall (4 screws) and let the
Cables ed with the terminal blocks go through the back cover
3) Connect all the terminal blocks on the printed circuit board
according to wiring diagram page 3.
4) Mount and screw the front cover unit on the back cover
4 screws - 4×60 mm 4 S6 wall plugs
Access Control Systems / Wander monitoring
“This device (FCC ID : R8T-PE3LR-C) complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation”
WARNING STATEMENT FOR MODULE:
Because of the power level and grant condions of the Zig-Bee module, the 20cm separaon distance warning statement is need-
ed. Please see below.: The antenna(s) used for this transmier must be installed to provide a minimum separaon distance of
20cm, and must not be co-located or operang in conjuncon with any other antenna or transmier.