Owner`s manual

DODGE / DURANGO / 2011-12 ADVENT DUAL PLAYER HEADREST VIDEO

Page 10 of 15

128-9070

F. Headrest Cable Connections

1. Connect cables 1B and 2B to 3B then snap

security clamp around the connectors, add wire tie

for strain relief, and apply foam tape.

(Figure F1a-c)

2. Secure the cables to the factory harness under

the seat add enough slack to allow the seat move

freely. (Figure F2)

3. Repeat steps 1-2 on driver’s side using cables

1A, 2A, and 3A. (Figure F3)

G. Reassemble Trim

1. Trim all wire tie ends

2. Reassemble all trim removed in earlier sections.

3. Make sure all factory connections are

reconnected and secure.

H. Complete Installation

1. Make sure vehicles battery is connected to

manufacturer’s specifications.

2. Install (2) AAA batteries in each remote and

headphone set.

3. After testing with steps on following pages,

carefully re-assemble vehicle by reversing steps in

section B.

Figure

F1a

Figure

F1b

Figure

F1c

Figure