Owner`s manual
DODGE / DURANGO / 2011-12 ADVENT DUAL PLAYER HEADREST VIDEO
© 2012 Advent All rights reserved.
Page 2 of 15
128-9070
Document 128-90707 Created 2/29/12
Kit Contents:
Item # Qty. Component Description
1 2
Headrest Assembly
2 1 IN9000 Pre-Pack
1 Power Cord#9
1 Power Cord#8
1 Standard Hardware Bag
4 AAA Battery
1 Cable 3A Red
1 Cable 3B Black
4 Cable clamps w Foam
1 Control Box
3 1 IN9010 Pre-Pack
2 FF Headphone w/Logo
2 Remote Control
4 AAA Battery
1 SL Owner’s Manual
4 1 IN3056-59 Pre Pack
2 Cap LH Mercedes-Chrysler 14mm H103
2 Cap RH Mercedes-Chrysler 14mm H103
5
1
IN3065 Pre-Pack
4 Spacers 306091a2
Hardware Bag Contents:
Item # Qty. Component Description
1 3 Wire Tie Base
2 2 Blue T-Taps
3 2 Double Sided Tape
4 3 Red T-Taps
5 12 6” Wire Tie
6 2 11” Wire Tie
7 1 Foam Tape
Additional Items Required For Installation:
Item # Qty. Component Description
1
Recommended Tools:
Safety Tools
Seat/Floor Covers Blankets
Installation Tools
Wire Cutters
Pliers
NRT (Nylon Removal Tool)
Special Tools
None
Special Chemicals
None
Color Applicability/ Trim Level:
Vehicle Trim Color
Accessory
Color
077100
Black
077101
M. Graystone
077102
Tan
077103
Lt. Frost
00000
00000
Black X
M. Graystone X
Tan X
Lt. Frost X
General Applicability:
LEGEND:
STOP:
Damage to the vehicle may occur. Do not
proceed until process has been complied with.
OPERATOR SAFETY:
Use caution to avoid risk of
injury.
CRITICAL PROCESS:
Proceed with caution to ensure
a quality installation. These points will be audited on a
completed vehicle installation.
TOOLS & EQUIPMENT: This calls out the specific
tools and equipment required for this process.
REVISION MARK:
This mark highlights a change in
installation with respect to previous issue.
INSTRUCTION/ INSTALLATION NOTES:
After Safety mandated preparatory steps have been taken,
the installation sequence is the suggested method for
completing the accessory installation.
When prying panels, use masking tape on all surfaces that a
tool may come in contact with to prevent marring.
After a wire tie is fully fastened, cleanly cut excess wire tie
length with a pair of wire cutters.
The wiring information is on an “as is” basis without any
representation or warranty. It is the installer’s responsibility
to verify any circuit before interfacing with it using a digital
multi-meter.
Manufacturer’s service documents can be used for any
vehicle disassembly that may be depicted differently from
what the instruction states.
Use Wiring Diagram on last page of document to clarify cable
or component names.