Owner`s manual

24
OVERHEAD DOME LIGHTS
The Dome Lights integrated into the unit are controlled by a three position slide switch. Sliding the switch to the ON position will turn the lights ON. The
OFF position will prevent the lights from turning ON with the vehicle's interior lighting. The AUTO position will allow the lights to turn ON and OFF with
the vehicle's interior lighting. Refer to the Installation Guide for wire connections. Do not leave the vehicle unattended with the dome light switch in the
ON position, as this could result in a discharged battery.
ACCESSORIES
WIRELESS HEADPHONES
The ADVDLX10 includes a built-in infrared transmitter for use with the supplied wireless headphones. The headphone volume is adjusted using the
controls on each headset. Any number of wireless headphones may be used but they must be used within a line of sight from the transmitter, as infrared
transmissions, like visible light, travel only in a straight line.
Note: If the monitor is set to M2 mode, the headphones supplied with this unit will not work, as these headphones are single channel. Only two-channel
wireless headphones will work with this unit when set to M2 mode. The only time it is necessary to set this unit to M2 mode is if there is an RSA (Rear
Seat Audio) installed in the vehicle or if two of these monitors are installed in one vehicle. Press the system menu and highlight monitor mode to change
the M1 mode to M2 mode or M2 mode to M1 mode.
SOURCE FEATURE
AV
An external video source, video game system, or other audio/video devices can be connected to the AV input. To access the audio / video inputs, inputs,
turn the unit on and press the S (source) button or the SRC button on the remote control until "AV” is displayed on the screen. Turn the video source
component on with its power button or remote control and it is now ready to play the audio and video signals from the source connected to AV.
AUX
The AUX input may be connected to a external video source, video game system or other audio/video devices via AUX harness input, turn the unit ON
and press the S (Source) button or the SRC button on the remote until “AUX” is displayed on screen. Turn the video source component on with its power
button or remote control and it is now ready to play the audio and video signal from the source connected to AUX.
AV Out
The unit provides an AV output for optional video monitor(s). This output will provide the AV signals that duplicate the picture/audio being processed by
the unit to an additional monitor or video display. Please see your installer for more information.