Specifications

ADVR.010.00.00.000 РЭ. Sheet 10 of 26
7 Control Panel Functions
7.1 The control panel is intended for:
-heater activation and deactivation in manual mode;
-setting operation mode according to desired power or temperature;
-heater status indication (from the sensor integrated in the heater, control panel unit or
external sensor if connected;
-failure code indication in case of heater failure while operation.
The front board of the panel contains: four-digit light emitting doide (LED)
indicator, two LEDs and three knobs. Functionality of the knobs and LEDs. (fig.7.1)
LED indicator N1
(temperature mode)
(power mode)
LED indicator N2
mode selecting/decreasing
of power or temperature
Sensor selecting/increasing of
powerortemperature
Setting of operation mode/heater
ON-OFF knob
12
C
a
b
i
n
t
e
m
p
e
r
a
t
u
r
e
s
e
n
s
o
r
(if connected)
Heater temperature
sensor
Control panel
temperature sensor
LED indicator N1
(temperature mode)
(power mode)
LED indicator N2
mode selecting/decreasing
of power or temperature
Sensor selecting/increasing of
powerortemperature
Setting of operation mode/heater
ON-OFF knob
12
C
a
b
i
n
t
e
m
p
e
r
a
t
u
r
e
s
e
n
s
o
r
(if connected)
Heater temperature
sensor
Control panel
temperature sensor
Fig. 7.1- Control panel
While first time the heater is connected to electric circuit of the car or after
breaks of power supply, according to environmental temperature there will be
following information on the panel (for example)- the temperature in the area of the
sensor installed in the heater is -12°C (drawing 7,2), if the temperature in the area of
the sensor is above zero, there will be no “mines” before the figure.
12
12
fig 7.2- View of the indicator after connection to electric circuit of the heater (initial
stage of the indicator)