Specifications

ADVR.010.00.00.000 RE. Sheet 20 of 26
When installing the fuel supply line, do not allow connecting sleeves to bend.
Use a sharp knife to cut the fuel tube as in Figure 8.7. The cutting location shall be free
of indentations, hairs and must not restrict flow through the tube.
Правильно
Неправильно
Incorrect Correct
Figure 8.7 – Tube Cutting Prior to Installation
ATTENTION 1. Do not allow the fuel supply line or fuel supply pump to
overheat. Do not install the fuel supply line and fuel supply pump near the
exhaust pipe or on top of the engine.
2 The fuel supply line connecting the fuel supply pump to the
heating element of the heater should be installed at the same lifting angle.
8.5 Installation of Heater Electric Circuit
Heater wire harnesses shall be installed in compliance with the heater wiring
system as shown in Figure 4.1. When installing, do not allow the wire harnesses to
become overheated, deformed or dislodged during vehicle use. Attach the harnesses to
the vehicle fittings using plastic clamps.
Attention! Remove the fuse prior to installation.
8.6 Control Panel Installation
Install the control panel on to the dashboard in the cabin or passenger
compartment of the vehicle. Attach the Control panel with the help of adhesive tape.
Degrease the surface on which the panel is installed and remove protective film from
the adhesive tape.