Specifications

ADVR.010.00.00.000 RE. Sheet 21 of 26
9 Post-installation Testing
9.1 When installing, ensure that:
- the fuel supply lines of the fuel supply system are leak-proof and all clamps
are securely tightened,
- the electric contacts of the harnesses and heater elements are securely
installed,
- the shift knob located on the control panel is turned to the far left position by
being turned anti-clockwise as far as it will go following the click.
9.2 Install fuse 25А .
9.3. Fill the fuel pipe system with fuel with the help of fuel pumping
device(fuel pumping device УПТ-1 can be ordered at manufacturer).After filling the
system check that the fuel pump system is not leaking.
9.4 Check that the heater is working :
- in ventilating mode,
- in heating mode.
The process of activation begins with purging of the combustion chamber. After
purging the process of combustion begins and the heater goes on working in operation
mode.
9.5. Deactivate the heater. While switching off the heater the fuel stops entering
and the process of ventilation of the combustion chamber and heat exchanger starts.
9.6 Activate the heater while the vehicle engine is running and ensure that the
heater is operational.
ATTENTION! 1 When performing initial ignition following installation, the fuel
supply line should be filled with fuel using a fuel pumping device until the fuel
level reaches the inlet plug of the heater. If there is no pumping device, restart the
heater as many times as necessary to fill the fuel supply line.
2 Remember that each time the heater fails to start at the first
attempt, the heater will be restarted automatically by the control unit. If the
heater is not activated after 2 attempts, there will be malfunction code on the
Control panel.
10. Recommendations
10.1 To ensure consistent performance, the heater should be switched on for up to
5 minutes each month throughout the year (warm seasons included). This will prevent
the moving parts of the fuel supply pump from sticking,(which may be caused by
leaving the heater movable fittings in low-quality fuel for a long period of time).
10.2 Reliable performance depends on the type of fuel used depending on the
atmospheric temperature.