Specifications

ADVR.010.00.00.000 RE. Sheet 4 of 26
3 Safety Measures
3.1 The installation of the heater and its fittings shall be performed by authorized
organizations only.
3.2 The heater may only be used for the purposes specified herein.
3.3 The fuel supply line shall not be installed inside the passenger compartment or
cabin of a motor vehicle.
3.4 A vehicle that uses the heater shall be equipped with a fire extinguisher.
3.5 The environment where the heater is to be used shall be free of highly
inflammable vapours and a large quantity of dust.
3.6 To prevent the possibility of exhaust gas poisoning, the heater shall not be
used when the vehicle is in an enclosed area (garage, workshop, etc).
3.7 When refueling the vehicle, the heater shall be switched off.
3.8 When performing welding operations on the vehicle or repairs on the heater,
disconnect the heater from the vehicle battery.
3.9 When assembling or dismantling the heater, observe the safety measures
specified by electric work regulations for the fuel supply system and the vehicle’s
wiring system.
3.10 The heater shall not be connected to the vehicle electric circuit while the
engine is running or the battery is switched off.
3.11 The heater’s electric power supply must not be disconnected before the
end of the purge cycle.
3.12 The heater’s connectors must not be connected or disconnected while the
heater’s electric power supply is turned on.
3.13 Wait 5 to 10 seconds before switching the heater back on.
3.14 In the event of two subsequent ignition failures, contact the maintenance
department to report a malfunction.
3.15 In the event of a failure in heater operation, contact a designated repair
organization authorized by the Manufacturer.
3.16 Manufacturer warranty shall not apply if the above requirements are not
adequately met.