Setup guide

Advidia A-46 Mini Dome
10/16/2012 Page 4
A. Network Connection
o To set the network camera via a LAN (Local Area Network), please refer to Section A.1
Configuring Camera using LAN.
o To set the network camera via a WAN (Wide Area Network), please refer to Section B.2
Configuring Camera using WAN.
A.1 Configuring Camera using LAN
To view and configure the camera via a LAN, you need to connect the network camera in the
same subnet with your computer, and install the SADP or iVMS-4200 software to search and
change the IP of the network camera.
Note: For the detailed introduction of SADP, please refer to Appendix 1.
The following figures show the two ways of cable connection of a network camera and a
computer:
o To test the network camera, you can directly connect the network camera to the
computer with a network cable as shown in Figure 2-1.
o Refer to the Figure 2-2 to set the network camera over the LAN via a switch or a router.
Figure 1-1 Connecting Directly
Figure 1-2 Connecting via a Switch or a Router