Instructions / Assembly

To make sure the house is straight, use a

pencil and a level to draw a vertical

guide on the surface on which you wish

to put the house.

Unroll and remove the protective ﬁlm on

the back, starting at the tip for about 60 cm

For the installation of wooden slats. Remove the protective

ﬁlm from the adhesive on the back of the strips and apply on

the edge of the vinyl house, starting with the top of the house.

Press ﬁrmly on the wood slats to ensure proper adhesion.

And there you have it, your house is installed!

Stick the top of the house on the surface,

gently smoothing to achieve a uniform

adhesion without air bubble, while

removing the rest of the protective ﬁlm.

SELF-ADHESIVE WRITE-ON HOUSE

INSTRUCTIONS

5 x wood pieces with adhesive tape

A B C

CUSTOMER SERVICE 1.866.992.3943

The surface on which I will apply my write-on house

must be clean, dry and smooth

chalkboard adhesive vinyl

dry erase adhesive vinyl

PAGE 1
INSTRUCTIONS SELF-ADHESIVE WRITE-ON HOUSE The surface on which I will apply my write-on house must be clean, dry and smooth 5 x wood pieces with adhesive tape chalkboard adhesive vinyl or dry erase adhesive vinyl A B C To make sure the house is straight, use a pencil and a level to draw a vertical guide on the surface on which you wish to put the house.
PAGE 2
MODE D’EMPLOI MAISON À ÉCRIRE AUTOADHÉSIVE La surface sur laquelle je vais appliquer ma maison à écrire doit être propre, sèche et lisse 5 x lamelles de bois avec ruban adhésif vinyle noir à craie ou vinyle blanc effaçable A B C Pour que la maison soit droite, utiliser un crayon pour tracer un guide vertical à l’aide d’un niveau à l’endroit où vous désirez apposer la maison. Dérouler et retirer le film protecteur au dos à partir de la pointe sur environ 60 cm.