Instruction manual

ManualsBrandsAE ManualsBattery ChargersBattery Conditioner and Charger

Rev. P-071510 P/N VDC12248-MNL

BatteryMINDer

Model 12248

Page 12

1) Battery clip cordset w/ qwik connect plug (pgs.13, 16)

2) Ring terminal cordset w/ qwik connect plug (pgs. 13, 16)

3) Mounting tabs

4) Input power cordset (pg. 13, 18)

5) Output cord w/ qwik connect plug (pg. 13, 16)

6) Temperature sensor input connector (pg. 13, 17, 21)

7) Charge rate selection button (pg. 13, 17, 18)

8) Battery type selection button (pgs. 13, 17, 18)

9) Stop/Restart selection button (pgs. 13, 17, 18)

10) LED indicators for power, connection, fault, battery

condition, charge status (pgs.13-15, 18–20, 24)

11) 12 Volt Power cordset (Optional)

12) Temperature sensor with cord and ring terminal (pgs. 17,

21 - 24) (Optional)

4 A

9LL=JQ'#(=J

Charger / Maintainer /

Full Time De-Sulfator - Conditioner

12-Volt @ 2/4/8 Amp

Model 12248

8 A

2 A

AGM

GEL

FLOODED

Select

Charge Rate

Select

Battery Type

PRESSPRESSPRESS

Battery Condition Indication

Power On & Battery Connected

Before Start Charge:

Green = OK - Accepted

Yellow = Weak / Sulfated / Deep Discharge

After Charge:

Green = Good

Yellow = Sulfated / Weak

MAINTENANCE

(FLOAT)

Stop

Restart

VDC Electronics, Inc.

800-379-5579 (ET)

www.batteryminders.com

U.S. Patented & Patent Pending

Hold for 5 sec. for full reset

Green = Power ON

ERROR:

Red = Polarity Reversed

/ Battery = less than 3-Volts

Red (Blinking) = Battery not fully charged -

charger in float-maintenance mode

Charge - Float

Green (solid) = Charging

Green (blinking) = Float (maintenance)

See Instruction Manual

For Lead-Acid

Batteries ONLY