Instruction manual

Rev. P-071510 P/N VDC12248-MNL
BatteryMINDer
®
Model 12248
Page 17
Correct polarity and a good connection will be
your reward. Attach the BCA to the proper bat-
tery posts, clamps or screw terminals, depending
on type of battery. ALWAYS connect the nega-
tive (Black) clip to a metal grounding point
(Negative ground installations such as most
modern cars, trucks, boats, RVs, etc.) as far
away from battery as possible for maximum
safety. Never connect to any type of fuel line.
Note: Older vehicles or other devices may be
Positive ground installations requiring differ-
ent connection recommendations. If unfamiliar or
unsure which battery type of grounding system
you have, check with our Tech Support personnel
before proceeding further.
Note: Temperature compensation Sensor
Assembly (Part# ABS-248) (OPTIONAL). See
pages 21 - 24 for full detailed instructions.
3. Determine the type of battery you wish to
charge. When certain press the Select Battery
Type button. The most common is the Flooded
kind, distinguished by removable filler caps (6)
or two (2) manifold covers (Maintenance-Free)
which should not be removed unless specifically
allowed by the battery manufacturer. The second
most popular is the Absorbed Glass Mat (AGM)
sealed-valve regulated type. Lastly is the sealed
valve regulated Gel battery.
Note: If unsure of your battery type, check with the
battery seller, manufacturer or our Tech Support
before proceeding further. The normal (default)
setting of your charger is GEL, as this is the low-
est voltage output and thus the one least likely to
cause your battery to be overcharged, should
you incorrectly select the wrong battery type.
However be aware that using the wrong set-
ting for a particular type battery can dramatically
shorten its life and/or cause potentially explosive
gas to be emitted from the battery.