User's Manual

ENGLISH

MUTE

The Mute status is indicated on the transmitter by the crossed off loudspeaker symbol and the blue status LED

(5) flashes once per second.

To switch from the normal status (functioning) to Mute, or vice versa, hold down the button (6) for a second.

8.3.2 SCREEN 2

Press and release the button (6) to switch from the main screen to screen 2.

This screen displays:

• The version of the firmware installed in the device.

• The microphone capsule amplification gain (expressed in dB).

• The power of the signal transmitted to the receiver (expressed in mW).

• The mute indicator.

• The battery level indicator.

ADJUSTING THE GAIN

The gain can only be changed directly on your MOVING D-B transmitter using

the PLUS (3) and MINUS (2) buttons located inside the front panel of the

transmitter.

Note. If the red LED (5) turns on during normal transmitter operation to indicate

a signal peak, adjust the gain on the input level using the buttons.

8.4 TRANSMITTER CONFIGURATION

The transmitter is configured through the receiver.

• Set the desired configurations in the various menus of the MOVING D-R receiver (for more details see the

manual section concerning the receiver).

• Turn on the transmitter.

• Open the front panel on the MOVING D-B transmitter. Press the PLUS (3) and MINUS (2) buttons at the

same time until “IrDA ON” appears on the display.

• Align the transmitter's IRDA interface with the one for the receiver (recommended distance between 5 and

10 cm), see figure below.

• On the receiver: use the Up button to enter menu 1 (TX CONFIGURATION) and turn the Select knob to

select Write Data, then press the button to confirm (OK).

• Wait for the operation to finish, making sure not to interrupt the IRDA connection between the two devices.