Specifications

Printed in the U.S.A.

AE8-1368 R2

8. Remove access cover on control module (two

screws).

9. Unplug RS-485 communications plug.

10. Unplug the harness to the oil pressure switch.

11. Remove housing cover nuts securing control

module mounting plate to compressor. (x2)

12. Remove control module and harness assembly

as a unit by pulling it off towards the front of the

compressor.

13. Remove the compressor from the rack using proper

tools and procedures to assure safety, and to

prevent damage to the rack or other compressors.

10.0 Installation of the compressor (2D/3D)

1. Mount the new compressor in the rack, lifting

and maneuvering the compressor in a manner to

prevent personal injury and damage to the other

compressors on the rack.

2. Install the control module and harness assembly

on the new compressor as a unit.

3. Install the housing cover nuts securing the control

module mounting plate to the compressor. (x2)

4. Transfer the temperature sensor and pressure

control ﬁ ttings to the head and body of the new

compressor. Use of a thread sealing compound

is recommended. Connect temperature probe to

wiring harness.

5. Install high pressure cutout switch (RED DOT -

360 psi) on the head, and low pressure cutout

switch (WHITE DOT - 3 psi) on the compressor

body. Double Check Positions! Connect pressure

controls to wiring harness (HPCO-RED leads and

LPCO-BLUE leads).

Figure 7.1

2D/3D CoreSense Diagnostics v2.11 Assembly Reference Drawing

Figure 7.2 – 2D/3D Terminal Box Connections