Parts List

- 13 -
AEE Unmanned Aircraft System
s o lProfes i na Leading
The nose LED indicator shows the nose direction of drone and the white light will be normally on after
the drone is started. The tail LED indicator shows the current status of flight control system. Please
refer to the status of flight control system represented by flickering modes.
2.4 Auto takeoff/landing
The MACH6 drone supports one-key takeoff and landing. Press “One-key takeoff/landing” button and
enter “ ” to set the takeoff height.
Steps of use.
1. Enter “ ” in the main interface of remote control and set the takeoff height in “UAV setting interface
– Takeoff height”. The default takeoff height is 16.4041995(ft); the min. and max. takeoff height are
16.4041995(ft) and 393.7007874(ft) respectively.
2. Once height setting is done, short press “One-button takeoff/landing” button of remote control, the
main interface of remote control will pop up the dialogue box of “Are you sure to enter one-button
takeoff?”; the drone will unlock vertical takeoff and suspend at the designated height.
3. Short press again and the main interface of remote control will pop up dialogue box of “Are you
sure to land?”; the drone will land vertically and lock the propellers automatically.
2.5 One-button route
The MACH6 drone supports one-button auto route mission. Press “One-button route” on remote control
or enter the map to set “ ” “Edit route” “Execute route”.
Steps of use:
Introduction to drone status indicators
Normal status
Power-on self-test
High Velocity Mode
POS HOLD Mode
ATTI mode
Return flight
Upgrade firmware
Compass calibration:
Accelerator calibration:
Battery level alarm
Warning and fault
Battery level alarm
Drone and remote control
signal is lost
During power-on self-test, the tail LED will flicker alternatively in red, yellow, purple and green; it will
become red when self-test is passed
When GPS signal is sufficiently acquired, the Tail LED will be Green. If GPS signal is not sufficient the
LED will be Red.
When GPS signal is sufficiently acquired, the Tail LED will be Green. If GPS signal is not sufficient the
LED will be Red.
The tail LED is normally on in red.
The tail light flickers alternatively between purple and green.
The blue light flickers quickly during upgrade.
Slow flickering from yellow light to green light. When satellite signal is received and locked, the green
light will be normally on; otherwise, the red light will be normally on.
Calibration mode is entered when blue light is on; the blue light flickers during calibration; when calibration
is done, the blue light is normally on; the green light will be normally on when level calibration is done.
Battery level alarm
Battery level alarm
Drone and remote control signal is lost