Parts List

- 15 -
AEE Unmanned Aircraft System
s o lProfes i na Leading
2.6 Auto return
The Mach 6 supports Return to Hom (RTH) function. The Home Point is defined point at which the GPS
signal is acquired. When the communication signal is lost between the remote and the drone, RTH is
initiated automatically. The Mach 6 supports 4 RTH modes, one button return, low battery alert return,
mission completion return, and control signal loss return.
2.6.2 Low battery return (auto calculation function will be further added)
The low battery return can be set in “ ” and the drone will return automatically in case of low battery.
2.6.1 One-button return
Press “One-button return” key on remote control to trigger one-button return. The user may use one-
button return function when the drone is beyond the visible range and the nose direction is unknown.
Return height: When drone height is lower than 49 ft, the drone will firstly climb to the height of 49ft and
then start returning. When drone height is over 49ft, the drone will return directly at the current height.
During return, the drone’s flight mode will become “return”; meanwhile, the tail green light and purple
light will flicker alternatively. The user can quit the return mode through “Flight mode switch” on the
remote control, to control the drone again.
Note: 1. It is recommended to enter the middle position (POS HOLD Mode) after flight mode is switched.
2. If the switch is pulled to down position (ATTI Mode), pay close attention to the drone to avoid safety
accident.
As the default setting, the return when the first-level alarm is triggered, or the drone will land when
the second-level alarm is triggered. This function can be changed through user setting, and the drone
will have corresponding actions after 3-5s when reaching the set alarm threshold of battery level. The
user can stop the first-level alarm action through mode switch to control the drone again. However,
if the first-level alarm is stopped, the set action will not be executed; instead, remote control will have
prompt and buzzing and the tail light of drone will flicker slowly in red. The second-level alarm action
is compulsory and cannot be stopped, but the user can control the flying of drone to land at safe place.