Parts List

- 20 -
AEE Unmanned Aircraft System
s o lProfes i na Leading
99~100%
80~99%
60~80%
40~60%
Less than 20~40%
“ ” “ ”
Indicates that the LED
light flashes slowly
Indicates that the LED
light flashes quickly
3.4.3 The indicator definition during charging is as follows:
3.4.3.1 Details of charging completion:
Once charging is done, the LED indicator of charger will turn green from red. Please disconnect the
charger from battery according to the following sequence, to avoid short circuit due to accidental
contact between positive and negative pole.
1. Firstly, turn off the charger and remove the plug of external power wire;
2. Unplug the charging wire on battery;
Note: 1. The intelligent battery must be charged by the specific charger provided by AEE; otherwise,
the consequences should not be undertaken by AEE.
2. In order to avoid short circuit caused by accidental contact of anode and cathode charging connector,
battery damage or other safety accidents, it is strictly prohibited to remove charging from the charger
before turning off the power switch. It is recommended to charge the battery in fire-proof place and
take proper protection measures; it is forbidden to charge the battery indoors.
3.4.4 Charging protection indicator
3.4.5 Notes of using intelligent battery
1. Do not remove or reassemble the battery.
2. Do not short circuit the battery or connect it in reverse electrode.
3. Do not use near heat sources.
4. Do not put the battery into water or wet it.
5. Do not charge near fire or under direct sunlight.
6. Do not crush or throw it.
7. Do not use the battery under the condition of serious damage or deformation.
8. No reverse charging or over discharging (otherwise, it may cause battery bulging, leakage, cell
breakdown, even explosion, etc.)
9. It is forbidden to open or disassemble the battery.
10. Waste batteries should be recycled for environmental protection.
3.4.6 Maintenance & transport of intelligent battery
1. If the battery is not used for a long time, it is recommended to take out the battery and place it
separately and charge and discharge it every 3 months. First, discharge the battery to 3.75V,
then fill it to 4.2V, and finally put it to 3.85V to store the cell (single chip) to maintain the battery
performance and extend the service life of the battery.
2. For safety concern, the battery should be discharged in advance during transport. Discharge the
single piece to 3.75V~3.8V.
“■”
Battery Level Indicator
LED1 LED2 LED3 LED4
Current Battery Level
■
■ ■
■ ■ ■
□ □ □ □
LED indicator is normally on