User's Manual

- 3 -
Note: In the state of second-level low power, the aircraft will enter the protection mode, and will slowly descend to the ground
vertically at the current position. At this time, the attitude and altitude of the aircraft can still be controlled by the remote control,
but two points need to be noted: ① After the aircraft is in the state of second-level low power for 5S, it will start to land
automatically, regardless of the middle of the throttle. ② The aircraft can still be operated in the state of second-level low power.
The mode switching button can be used to change the mode to regain the control altitude and speed. When the aircraft is not
operated, its automatic landing speed is 1M/s. When the aircraft and the remote control give low power alarm, please carefully
choose whether to fly or not. It is recommended to replace the battery before flight, in case of flight accident caused by insufficient
power of the aircraft and remote control.
Charging of the remote control
The Y12 remote control has a built-in high-performance large-capacity battery (5,600 mAH), which can work
continuously for three hours. Please use a special charger when charging the battery, as shown below:
Charging indicator Charging status
Red light Charging...
Blue light Charging completed
Battery voltage check of the remote control
Power detection before power on: Short press the power button of the remote control, and the left status light
will show the current remote control power, as shown in the following table (figure):
AEE Unmanned Aircraft System
Professional Leading