User Guide

Fig. 6

FO 0392

Injectors replacement

 Remove the pan supports.

 Remove the burner's caps and crowns.

 With a socket spanner 7 unscrew and remove

the injectors (Fig. 6), and replace them with the

ones required for the type of gas in use (see

Technical data).

 Reassemble the parts, following the same

procedure backwards.

 Replace the rating label (placed near the gas

supply pipe) with the relevant one for the new

type of gas supply. You can find this label in the

package of the injectors supplied with the

appliance.

Should the feeding gas pressure be different or variable

compared with the required pressure, an appropriate pressure adjuster must be fitted on the gas

supply pipe, in compliance with the rules in force.

Adjustment of minimum level

To adjust the minimum level of the burners,

proceed as follows:

 Light the burner.

 Turn the knob on the minimum position.

 Remove the knob.

 With a thin screwdriver, adjust the by-

pass screw (see Fig. 7). If changing

from natural gas to LPG,completely

tighten clockwise the screw, until a

small regular flame is obtained. If

changing from LPG to natural gas

unscrew about 1/4 turn the by-pass screw, until a small regular flame is obtained.

 Finally check the flame does not go out when quickly turning the knob from the maximum position

to the minimum position.

This procedure can easily be carried out, anyhow the hob has been positioned or built in

the working top.

Adaptation to different types of gas

Fig. 7

By-pass