User manual Cooker FCM660N
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Before first use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Hob - Daily Use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Hob - Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ Hob - Care and Cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 5 6 6 7 7 Oven - Daily Use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 Oven - Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Oven - Care and Cleaning _ _ _ _ _ _ _ _ _
• Information on the voltage is on the rating plate. • You must have the correct isolation devices: line protecting cut-outs, fuses (screw type fuses removed from the holder), earth leakage trips and contactors. • The electrical installation must have an isolation device which lets you disconnect the appliance from the mains at all poles. The isolation device must have a contact opening width of minimum 3 mm. • The shock protection parts must be fixed in such a way that they cannot be undone without tools.
• If an object or cookware falls on the hob surface, the surface can be damaged. • Do not put hot cookware near to the control panel because the heat can cause a damage to the appliance. • Be careful when you remove or install the accessories to prevent damage to the appliance enamel. • Cookware made of cast iron, cast aluminium or with damaged bottoms can scratch the hob surface if you move them on the surface. • Discoloration of the enamel has no effect on the performance of the appliance.
– Discard the door catch. This prevents children or small animals from being closed inside of the appliance. There is a risk of suffocation.
Before first use Warning! Refer to "Safety information" chapter. Caution! To open the oven door, always hold the handle in the centre. Initial Cleaning • Remove all parts from the appliance. • Clean the appliance before first use. Caution! Do not use abrasive cleaning agents! This can damage the surface. Refer to chapter "Care and Cleaning". Preheating 1. 2. 3. Set function and maximum temperature. Run an empty oven for 45 minutes. and maximum temperature. Set function 4.
1. 2. Control knob Function 1-6 Heat settings (1 = lowest heat setting; 6= highest heat setting) Turn the knob to a necessary heat setting. The hob control indicator comes on. To deactivate the cooking zone, turn the knob to the “0” position. If all cooking zones are deactivated, the hob control indicator goes out. Rapid hot plate A red dot in the middle of the plate shows a rapid hot plate. A rapid hot plate heats up faster than usual plates. The red dots are painted on the plates.
• Stainless steel parts wash with water, and then dry with a soft cloth. • The pan supports are not dishwasher proof; they must be washed by hand. • Make sure you position the pan supports correctly after cleaning. • To make burners work correctly, make sure that the arms of the pan supports are in the centre of the burner. • Be very careful when you replace the pan supports to prevent the hob top from damage. After cleaning, dry the appliance with a soft cloth.
Oven - Helpful hints and tips Cooking meat and fish Caution! Use a deep baking tray for very moist cakes. Fruit juices can cause permanent stains on the enamel. • Do not cook meat with weight below 1 kg. Cooking too small quantities makes the meat too dry. • Use a dripping pan for very fatty food to prevent the oven from stains that can be permanent. • Leave the meat for approximately 15 minutes before carving so that the juice does not seep out.
Weight (g) Tray type Shelf level Preheating time (minutes) Temperature (°C) Cooking / baking time (minutes) Chicken, whole 1350 oven shelf at level 2, roasting tray at level 1 2 - 200-220 60-70 Chicken, half 1300 oven shelf at level 3, roasting tray at level 1 3 - 190-210 30-35 Pork roast cutlet 600 oven shelf at level 3, roasting tray at level 1 3 - 190-210 30-35 Flan bread 800 enamelled 2 20 230-250 10-15 Stuffed yeast cake 1200 enamelled 2 10-15 170-180 25-35 Pizz
Food Weight (g) Tray type Shelf level Preheating time (minutes) Temperature (°C) Cooking / baking time (minutes) Meringue 400 enamelled 2 - 100-120 40-50 Crumble cake 1500 enamelled 3 10-15 180-190 25-35 Sponge cake 600 enamelled 3 10 160-170 25-35 Buttered cake 600 enamelled 2 10 180-200 20-25 1) After you switch off the appliance, leave the cake in the oven for 7 minutes. 2) After you switch off the appliance, leave the cake in the oven for 10 minutes.
4 4 6 5 1 1 3 Close the oven door to the first opening position (halfway). Then pull forward and remove it from its seat. 4 Place the door on a stable surface protected by a soft cloth. Use a screwdriver to remove 2 screws from bottom edge of door Important! Do not loose the screws 3 2 2 6 Lift the inner door 7 Clean inner side of the door Clean the glass panel with water and soap. Dry it carefully.
3. Replace the oven light bulb with applicable 300°C heat-resistant oven light bulb. Use the same oven lamp type. 4. Install the glass cover. What to do if… Problem Possible cause Remedy There is no spark when lighting the gas There is no electrical supply Make sure that the unit is connected and the electrical supply is switched on. There is no spark when lighting the gas There is no electrical supply Examine the house electrical installation fuse.
Location of the appliance Technical Data You can install your freestanding appliance with cabinets on one or two sides and in the corner. Appliance class 2, sub class 1 and class 1. Keep a distance of about 1 cm between the appliance and the wall to make sure that the lid opens.
Burner Normal power Reduced power kW kW 1,85 0,43 2,00 Rapid burner Type of gas Pressure Inj. Diameter Cons.
2 3 4 5 Gasket Adjustable connection LPG pipe holder Natural Gas pipe holder If you change from liquid gas to natural gas 20 mbar, undo the by-pass screw approximately 1/4 of a turn. The appliance is set to default gas, to change the setting choose pipe holder from the list. Always use the gasket sealing 1 Adjustment to different types of gas Warning! Let only an authorized person do the adjustment to different types of gas. This appliance is for operation with natural gas.
Environment concerns The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
www.electrolux.
