User Guide

Problem/Display Possible Cause Remedy
lights up
Automatic switch-off has been
triggered
Switch appliance off. Switch
appliance on again
and number are displayed
Electronics fault Disconnect the appliance from
the electrical supply for a few
minutes (Take the fuse out of
the house’s wiring system) If
after switching on again,
is
displayed again, call the cus-
tomer service department
Acoustic signal sounds when
appliance is switched off
The control panel is wholly or
partly covered by objects.
Remove objects.
Repeated acoustic signal (6x),
appliance switches off
One or more sensor fields have
been covered for longer than
10 seconds
Uncover sensor field
Acoustic signal sounds and ap-
pliance switches itself on and
then off again; after 5 seconds
another acoustic signal sounds
The On/Off sensor field has
been covered up, e.g. by a cloth
Do not place any objects on the
control panel
If you are unable to remedy the problem by following the above suggestions, please
contact your local Service Force Centre.
WARNING!
Repairs to the appliance are only to be carried out by qualified service engineers. Consid-
erable danger to the user may result from improper repairs.
If the appliance has been operated incorrectly, the engineer's visit will be chargeable, even
during the warranty period.
Operating noises
Depending on the material and the processing of the base, the following noises may occur
when using induction cooking zones.
•Cracking noise
1
when using cookware made of different mate-
rials (Sandwich construction)
• Whistling
1
when using an individual cooking zone or sev-
eral cooking zones with high powers when the
cookware is made of different materials (Sand-
wich construction)
• Humming
2
can occur at high power levels
• Clicking
2
during electric switching processes
1
3
2
What to do if ...
15