PERFECT DB 50..
1 E F D G H J K C L M B P A N O a MAX b c X d 2 2 MA 3
A B 4 5 6/A 6/B 7 8 3
g Ironing table - Recommendations for use Fabric Temperature Selector Steam Selector g Comments Synthetics Polyacrilic Acrylan, Dralon, Lycra, Orlon, Vonnel Steam off “0” Polyamide Polyester Enkalon, Grilon, Nylon, Perlon Rilsan Dacron, Diolen, Kodel, Trevira, Vestan Steam off “0” Cellulose Cellulose fibres, acetate, cupro, viscose such as: Cuprama, Colvera, Phyron, Rayon, Tricell Natural fibres Silk Steam off “0” Silk, wool and synthetic fibres can be dry-ironed by covering with a damp clot
g g Dear customer Please read these operating instructions carefully. Above all please observe the safety instructions on the initial pages of these operating instructions! Please keep these operating instructions for future reference. Pass them on to any subsequent owner of the appliance.
g neers. Considerable danger may result from improper repairs. If repairs become necessary, please contact the Customer Care Department or your authorised dealer. Technical Data Power consumption: 2000 W Mains voltage: 220 - 240 V ; This appliance complies with the following EU Directives: – 73/23/EEC of 19.02.1973 “Low voltage directive”, including modification directive 93/68/EEC. – 89/336/EEC of 03.05.1989 “EMC directive”, including modification directive 92/31/EEC.
g Ironing with Steam To steam iron, set the temperature selector (Figure 1/N) to the required fabric type and wait until the power indicator (Figure 1/J) goes out - only then set the steam selector(Figure 1/F) to position “1”, “2”, „3“ or “4” (Figure 4/B). You will find which temperature setting (fabric type) matches which steam setting in the ironing table. As soon as the steam iron is held horizontally steam begins to form. When the steam iron is set upright again the steam supply stops automatically.
g 0 Remove the plug from the mains. 0 Place the appliance horizontally on an iron rest or plate (Figure 5). 0 Set the steam selector (Figure 1/F) to position “4” (Figure 4/B) and allow all the mixture to flow through. 0 Afterwards repeat the procedure using clear water and then heat the steam iron briefly to allow the steam chambers to dry. Your steam iron is now ready for use again. As a precaution we recommend descaling every three months.
AEG Hausgeräte GmbH Muggenhofer Str. 135 D-90429 Nürnberg http://www.aeg-hausgeraete.
