User manual

10a

10b

Fig. 12

Extraction mode

Recirculation

mode

Fig. 13

• Fix the sides of the

cooker hood by

fastening the pins (10a)

to the sides of the

fastening screws (10b).

Only DD 8794 (not UK):

side panels are available

as a special accessory

please contact your local

Service Centre (or see

paragraph “Special

Accessory”).

Block the sides sliding

the two tabs outwards

(11).

• Make electrical

connection (12), but leave the hood disconnected from the home

mains circuit.

• In the case that it is decided to use the cooker hood in the mains

circuit, then place one of the two flanges provided in the exit hole (13

– Extraction). Attention! The tall flange should be used when a

telescopic chimney is required to be mounted (this item should be

ordered – see special accessories), the short flange is to be used in

all other cases.

• Remount the grease filter and the front panels

according to the numbering

noted also on the back of each

screen (from 1 to 4 from the top

to the bottom).

• Connect the hood to the home

mains circuit and check if the

hood works properly.