User Guide
12 care and maintenance frost free refrigeration
warning
Before changing any light bulb, switch the power off
at the power point and remove the power cord from
the power point�
Changing the light bulb
1. Switch off the power at the power
point and remove the refrigerator’s
power cord from the power point.
2. Remove shelves.
3. Carefully unclip the light cover. You
do this by pulling the upper part of
the cover towards the front of the cabinet.
4. Unscrew the light bulb and replace it with a bulb that is
the same as the original. If, when you remove the light
bulb the small rubber “O” ring comes out with the bulb,
fit the “O” ring over the new bulb and screw bulb into
the socket (see diagram).
warning
Never insert your finger into the light bulb
socket to check for the presence of the “O” ring�
5. Replace the light cover by hooking the light cover lugs
into the bottom of the housing and pressing the upper
part of the cover until it clips in.
6. Replace shelves.
7. Wait 5 minutes to ensure pressures in the refrigeration
system are equalized. Then reconnect and turn the
refrigerator on at the power point.
1. Switch off the power at the power point and remove the
refrigerator’s power cord from the power point.
2. Carefully unclip the light cover. You do this
by pulling the light cover tab at the rear
towards the front of the cabinet.
3. Unscrew the light bulb and replace it with
a bulb that is the same as the original. If,
when you remove the light bulb the small
rubber “O” ring comes out with the bulb, fit the “O” ring
over the new bulb and screw bulb into the socket (see
diagram).
warning
Never insert your finger into the light bulb
socket to check for the presence of the “O” ring.
4. Replace the light cover by hooking the light cover lugs
into the front of the housing and pressing the rear of the
cover up until it clips in.
5. Wait 5 minutes to ensure pressures in the refrigeration
system are equalized. Then reconnect and turn the
refrigerator on at the power point.
tips and information
Ensure the ‘O’ ring is in place before replacing the bulb�
Care and maintenance
Light bulb “O” ring Light socket
frost free refrigeration general information 13
Cleaning the appliance
warning
: Turn appliance off at the power
point, then remove power cord from socket� This will
make sure there is no chance of getting an
electric shock�
– stainless steel
Your stainless steel appliance is manufactured from a
mark resistant stainless steel. This stainless steel has
a special advanced protective coating that eases the
removal of marks such as finger prints and water spots.
To keep your stainless steel appliance looking at its best,
you should clean it regularly. You should only clean the
stainless steel doors with luke-warm soapy water and
a soft cloth, rinsing with clean water and then wipe the
surface with clean water and a soft clean cloth to remove
soap residue.
– pacific silver
You should only clean the pacific silver doors with luke-
warm soapy water and a soft cloth, rinsing with clean
water and then wipe the surface with clean water and a
soft clean cloth to remove soap residue.
caution
or other cleaners as they are likely to scratch the
covered by your warranty�
You should clean the appliance interior regularly. It will
be easiest to clean when the food supply is low. Wash
the interior with a soft cloth and use an unscented mild
soap with lukewarm water. Thoroughly dry all surfaces
and removable parts. Avoid getting water on appliance
controls. If you have taken out any removable parts,
replace them and switch the power on before re-
stocking the appliance with food. Naturally, you should
keep the interior of your appliance hygienic by promptly
and thoroughly wiping up any food spills.
Don’t use a steam cleaner. If live components come into
contact with condensing steam, they may short-circuit or
cause an electric shock.
Take care to keep door seals clean. Sticky food and
drink can cause seals to stick to the cabinet and
tear when you open the door. Wash seal with a mild
detergent and warm water. Rinse thoroughly and dry.
caution
Never use hot water, solvents, commercial kitchen
cleaners, aerosol cleaners, metal polishes, caustic or
abrasive cleaners, or scourers to clean this appliance,
as they will damage it� Many commercially available
cleaning products and detergents contain solvents
use only a soft cloth with an unscented mild soap and
lukewarm water�
This appliance complies to the following E.E.C Directives:
2006/95/EC: Low Voltage Directive
2004/108/EC: Electromagnetic Compatibility (EMC) Directive
92/75EEC: Energy Labelling
94/2/EC: Energy Labelling: Implementation for Refrigerators and Freezers
96/57/EC: Efficiency Requirements for Refrigerators and Freezers
93/68/EEC: Global Amendment Directive
2002/95/CE: Restriction on Hazardous Substances (RoHS).
Harmonised Standards to which Conformity is Declared:
92/7/5/EC:
EN153:1996 Energy Consumption: Refrigerators
89/336/EEC:
EN55014-1:1993 Emissions: Household and Similar Devices
EN55014-2:1997 Immunity: Household and Similar Devices
EN61000-3-2 Limits of harmonic current emissions
EN61000-3-3 Limits of voltage fluctuations and flicker
The symbol on the product or on its packaging indicates that this product may not be treated as household
waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and
electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential
negative consequences for the environment and human health, which could otherwise be caused by
inappropriate waste handling of this product. For more detailed information about recycling of this product,
please contact your local council, your household waste disposal service or the shop where you purchased
the product.
Height 1720mm 1720mm 1640mm 1720mm
Width 803mm 803mm 703mm 703mm
Depth 745mm 745mm 709mm 745mm
Climate class Ambient temperature
SN +10˚C to + 32˚C
N +16˚C to + 32˚C
ST +16˚C to + 38˚C
T +18˚C to + 43˚C
Technical data
The technical information is situated on the rating plate on
the internal left side of the appliance and on the energy label.
Read the “Safety Information” carefully for your safety
and correct operation of the appliance before installing
the appliance.
Installation
Positioning
Install this appliance at a location where the ambient
temperature corresponds to the climate class indicated
on the rating plate of the appliance:
warning