f r e e z e r / p a k a s t i n / f r y s s k å p / ÏÓÓÁËθÌËÍ INSTRUCTION MANUAL KÄYTTÖOHJE BRUKSANVISNING êìäéÇéÑëíÇé èé ùäëèãìÄíÄñàà EUU 11300 GB FIN S 2222 736-36 Downloaded from Fridge-Manual.
CONTENTS Instructions for the installer Instructions for the user Important Safety Instructions 3 Technical specifications Use 5 Installation Cleaning the interior Control panel Starting up Temperature regulation Quick freezing Warning light Acoustic alarm Freezing calendar Freezing of fresh foods Storage of commercially frozen food Thawing Ice-cube production Cold accumulators 5 5 5 5 5 6 6 6 6 6 6 6 6 Positioning Electrical connection Grid preparation Door reversal Building the appliance in under
IMPORTANT SAFETY INSTRUCTIONS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
■ ■ ■ ■ Attention: keep ventilation openings clear of obstruction. If the appliance is transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit. It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor. There are working parts in this product which heat up.
USE The freezer is marked with the symbol, which means that the compartment is suitable for freezing fresie food and long-term storage of frozen food. Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish.
Quick freezing 24 hours later. Once freezing is complete, the freezer should be reset for normal storage use. Food to be frozen has to be placed in the appliance's two top compartments; if freezing only a small amount of food, use the top compartment. The maximum amount of food which is freezable in 24 hours is indicated on the rating plate. This is to be found on the bottom left-hand side.
TIPS Tips for freezing fresh foods Tips for storage of commercially frozen food To help you get the best out of the freezing process, here are a few hints: ■ Freeze only good-quality, fresh and well-cleaned foods. Split them into small portions to speed up freezing and avoid having to thaw more food than you require. It is in fact important to remember that once the foods have thawed out, they deteriorate fast. ■ Another point to remember is that lean foods keep better and longer than fatty foods.
MAINTENANCE The appliance is equipped with an air inlet filter (1) and an air outlet duct (2) on the ventilation grid. Keep clean to guarantee good ventilation and good working order of the appliance. Unplug the appliance before carrying out any maintenance operation. Warning This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians.
SOMETHING NOT WORKING If the appliance is not functioning properly, check that: Dérangement Remède Appliance does not function, no pilot light is illuminated. - Appliance is not switched on; switch appliance on. - Mains plug is not inserted or is loose; insert mains plug. - Fuse has blown or is defective; check fuse, replace if necessary. - Mains socket is defective; Mains malfunctions are to be corrected by an electrician. The freezer temperature is not sufficient, red light lights up.
INSTALLATION Grid preparation lf this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. Remove the grid from the appliance pulling it towards you with hands. a Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc.
Door reversal The appliance must be unplugged before starting work. To reverse the opening direction of the door, proceed as follows: 1. Remove the top hinge (1) taking care not to let the door fall. 2. Remove the bottom door hinge (2). 3. Take out the plugs (3) from the holes (F) and reinsert them in the holes (F1) on the opposite side. 4. Refit the upper hinge (1) on the opposite side, on the bottom (position A). 5. Refit the door on the pin of the hige (1) in position A; 6.
UPPER SUPER. LOWER INFER. ca. 50 mm 90° E 21 m m E 90° ca. 50 mm 21 m m D319 Fasten the appliance to the worktop or the sides, applying the sealing strip between the appliance and adjacent cabinet using the fixing brackets (E). Place guide (Ha) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. Having drilled the holes, fix the guide with the screws supplied. Ha Hc 30 S.I.
Remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K).Should adjustment of the furniture door be necessary, use the clearance of slots as required. 8mm K Ha Place the small square on the guide again and fix it with the screws supplied. Should the lining up of the furniture door be necessary, use the clearance of slots. At the end of operations, it is necessary to check if the door of the furniture closes properly.
Electrolux HemProdukter AB S-105 45 Stockholm www.electrolux.se ELECTROLUX HOME PRODUCTS OPERATIONS EUROPE Downloaded from Fridge-Manual.
