EWS 103417 A ................................................ .............................................
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information Environment concerns Technical information Product description Control panel Programmes 2 3 4 4 5 6 Hints and tips 8 Before first use 9 Daily use 9 Care and cleaning 12 Troubleshooting 15 Installation 17 Subject to change without notice.
electrolux 3 • Do not install and connect a damaged appliance. • Make sure to remove all packaging and transport bolts. • Make sure that the mains plug is disconnected from the mains socket during installation. • Only a qualified person must do the electrical installation, the plumbing and the installation of the appliance. This to prevent the risks of structural damage or injury. • Do not install or use the appliance where the temperature is less than 0 °C.
electrolux TECHNICAL INFORMATION Dimensions Width / Height / Depth Electrical connection: Voltage Overall power Fuse Frequency 600 / 850 / 330 mm 220-240 V 2100 W 10 A 50 Hz IPX4 Level of protection against ingress of solid particles and moisture ensured by the protective cover, except where the low voltage equipment has no protection against moisture Water supply pressure Minimum 0,5 bar (0,05 MPa) Maximum 10 bar (1 MPa) Water supply 1) Cold water Maximum load Cotton Spin speed Maximum 3
electrolux 5 2 Large plastic caps To close the holes on the rear side of the cabinet after the removal of the transit bolts. 3 Plastic hose guide To connect the drain hose on the edge of a sink. 4 Small plastic caps To attach the protection cover to the bottom of the appliance.
electrolux EASY IRON BUTTON 4 Press this button to prevent the creases in the fabrics. When you press this button, the appliance decrease the intensity of the washing phase and spin speed. Automatically, the spin speed is set to 500 rpm. Set this function to iron the laundry easily and quickly. EXTRA RINSE BUTTON 5 Press this button to add rinsing phases to a programme. Use this function for persons allergic to detergents and in areas where the water is soft.
electrolux 7 Programme Temperature Type of load and soil Weight of load Programme phases White and coloured cotton with normal or light soil. max. 3.5 kg Wash Rinses Spin phase at the maximum speed Хлопок Цветное 30° C White and coloured cotton with light soil. max. 3.5 kg Wash Rinses Spin phase at the maximum speed Синтетика 60° C Synthetic or mixed fabric items with normal level of soil max. 1.
electrolux Programme Temperature Type of load and soil Weight of load Programme phases Possible functions Daily 40° C White and coloured cotton with daily level of soil. max. 2.5 kg Wash Rinses Spin phase at the maximum speed Стирка без нагрева White and coloured cotton with light soil. max. 3.5 kg Wash Rinses Spin phase at the maximum speed Полоскание All fabrics. max. 3.5 kg Rinse with additive Spin phase at the maximum speed Отжим Spin phase for hand washed laundry.
electrolux 9 • Do not wash in the appliance : – Laundry without hems or with cuts – Underwired bras. – Use a washing bag to wash small items. • A very small load can cause balance problems with the spin phase. If this occurs, adjust manually the items in the tub and start the spin phase again. STUBBORN STAINS For some stains, water and detergent is not sufficient. We recommend that you remove these stains before you put the items in the appliance. Special stain removers are available.
electrolux 3. Put the laundry in the appliance. 4. Use the correct quantity of detergent and additives. 5. Set and start the correct programme for the type of laundry and soil. LOADING THE LAUNDRY 1. Open the appliance door. 2. Put the laundry in the drum, one item at a time. Shake the items before you put them in the appliance. Make sure not to put too much laundry in the drum. Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. 3.
electrolux 11 3. Put it into the special guides in the middle of the compartment for the washing phase. When you use the detergent divider: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid detergent than the edge of the detergent divider. – Do not set the prewash phase. – Do not set the delay start function, if it is available. 4. Measure out the detergent and the fabric conditioner. 5. Carefully close the detergent dispenser. SETTING AND STARTING A PROGRAMME 1.
electrolux • Remove the laundry from the appliance. Make sure that the drum is empty. • Keep the door ajar, to prevent mildew and odours. • Close the water tap. The washing programme is completed, but there is water in the drum: – The Rinse Hold function or a programme that stops with water in the drum is set. – The door stays locked and the start button indicator flashes. – You must drain the water before to open the door. To drain the water: 1. If necessary, decrease the spin speed. 2.
electrolux 13 DETERGENT DISPENSER To clean the dispenser: 1. Press the lever and pull the dispenser out. Clean the pump if: • The appliance does not drain the water. • The drum cannot turn. • The appliance makes an unusual noise because of the blockage of the drain pump. Warning! 1. Disconnect the mains plug from the mains socket. 2. Do not remove the filter while the appliance operates. Do not clean the drain pump if the water in the appliance is hot.
electrolux 5. Unscrew the filter and remove it. • The appliance fills with the water for a long time. Warning! Disconnect the mains plug from the mains socket. 1 2 6. Remove fluff and objects from the pump. 7. Make sure that the impeller of the pump can turn. If this does not occur, contact the service centre. To clean the filter: 1. Close the water tap. 2. Remove the inlet hose behind the appliance. 3. Clean the filter in the valve with a stiff brush or a towel. 4. Install again the inlet hose.
electrolux 15 2. Start the programme to drain the water. FROST PRECAUTIONS If the appliance is installed in an area where the temperature can be less than 0 °C, remove the remaining water from the inlet hose and the drain pump. 1. Disconnect the mains plug from the mains socket. 2. Close the water tap. 3. Remove the water inlet hose 4. Put the two ends of the inlet hose in a container and let the water flow out of the hose. 5. Empty the drain pump. Refer to the emergency drain procedure 6.
electrolux Problem The appliance does not drain the water. The spin phase does not operate. There is water on the floor. You cannot open the appliance door. The appliance makes an unusual noise. Possible cause Possible solution The connection of the water inlet hose is not correct. Make sure that the connection is correct. The water pressure is too low. Contact your local water authority. The water drain hose is damaged. Make sure that the water drain hose has no damages.
electrolux 17 SERVICE Refer to the information supplied with this appliance for guarantee condition and point of contact. The information to give to the service is on the rating plate. We recommend that you write the information here: Model .................. Product number 914............. Serial number (S.N.) .................. INSTALLATION UNPACKING 1. Use the gloves. With a cutter remove the external film. 3. Remove the internal film. Do not to discard the plastic cover (A). A 4.
electrolux 5. Put the front piece on the floor behind the appliance. Carefully put down the appliance with the rear side on it. Make sure not to damage the hoses. 9. Remove the four bolts with a key. Pull out the plastic spacers. Remove the power supply cable and the drain hose from the hose holders. 2 6. Remove the polystyrene protection from the bottom. 1 10. Put the plastic caps in the holes. You can find these caps in the user manual bag. 1 2 7.
electrolux 19 x4 Caution! Make sure that there are no leaks from the couplings. x4 • The appliance must be level and stable. Do not use an extension hose if the inlet hose is too short. Contact the service centre for the replacement of the inlet hose. WATER DRAINAGE There are different procedures to connect the drain hose: With the plastic hose guide. • Caution! Do not put cardboard, wood or equivalent materials below the appliance feet to adjust the level.
electrolux • Directly to a built-in drain pipe in the room wall and tighten it with a clip. Without the plastic hose guide. • To a sink spigot. Refer to the illustration. Put the drain hose in the spigot and tighten it with a clip. Make sure that the drain hose makes a loop to prevent that remaining particles go in the appliance from the sink.
electrolux 21
electrolux
electrolux 23
www.electrolux.
