User manual

•
Delayed start
The Selected delay set by pressing the rel-
evant button appears on the display for
few seconds, then the duration of the se-
lected programme is displayed again.
•
Alarm codes
In the event of operating problems, some
alarm codes can be displayed, for example
E20 (see paragraph «What to do if...»).
• Incorrect option selection
If an option which is not compatible with
the set wash programme is selected, the
message Err is displayed at the bottom of
the display for a few seconds and the in-
tegrated red light of button 8 start flashing.
• End of programme
When the programme has finished three
flashing zeros are displayed, the pilot light
9 and the pilot light of button 8 go out and
the door can be opened.
7.2: Washing programme phase icons
•
Wash
•
Rinses
•
Drain
•
Spin
•
Dry
By selecting the wash programme, the
washing programme phase icons corre-
sponding to the various phases making up
the programme are shown in the bottom part
of the display. After having pressed button
8 only the icon of the running phase stays on.
7.3: Soil degree icons
•
Intensive
•
Normal
•
Daily
•
Light
•
Quick
•
Super Quick
•
Refresh
•
Super Refresh
When selecting a programme on the display
appears an icon indicating the degree of soil-
ing automatically proposed by the machine.
7.4: Child safety lock
(see «Child Safety
Lock» paragraph).
First use
• Ensure that the electrical and water
connections comply with the installa-
tion instructions.
• Remove the polystyrene block and
any material from the drum.
• Pour 2 liters of water into the main
wash compartment
of the deter-
gent drawer in order to activate the
ECO valve. Then run a cotton cycle at
the highest temperature without any
laundry in the machine, to remove any
manufacturing residue from the drum
and tub. Pour 1/2 a measure of de-
tergent into the main wash compart-
ment and start the machine.
Personalisation
Acoustic signals
The machine is provided with an acoustic
device, which sounds in the following cases:
• at the end of the cycle
• if there is a fault.
By pressing the 4 and 5 buttons simultane-
ously for about 6 seconds , the acoustic
signal is deactivated (except if there is a fault).
By pressing these 2 buttons again, the
acoustic signal is reactivated.
Child safety lock
This device permits you to leave the appli-
ance unattended and not to worry that chil-
dren might be injured by or cause damage to
the appliance. This function remains enabled
also when the washing machine is not work-
ing.
There are two different ways to set this op-
tion:
1.
Before pressing button 8 : it will be im-
possible to start the machine.
2. After pressing button 8 : it will be impos-
sible to change any other programme or
option.
To enable or disable this option press simul-
taneously for about 6 seconds buttons 5 and
6 until on the display, the icon
appears or
disappears.
8 electrolux
Downloaded From WashingMachine-Manual.com Manuals