INSTALLATION AND OPERATING INSTRUCTIONS Mod.
X GB GENERAL INFORMATION The Guarantee Your new appliance is covered by a guarantee. You will find the related Guarantee certificate attached. If it is missing, ask the Retailer for it, indicating the purchase date, model and serial number that are printed on the label identifying the appliance (located in the upper panel of the oven). Keep the smaller part of the certificate itself and show it if needed to the Technical Assistance Service staff along with the sales receipt or accompanying invoice.
X GB INDEX Technical features .............................................................................................................................................................................page 3 Installation........................................................................................................................................................................................page 3 Gas connection ....................................................................................
The yellow/green earth wire should not be controlled by the switch. The plug or monophase switch used for mains supply connection should be easy to access when the appliance is in position. Important: position the mains supply cable so that it is never subjected to a temperature more than 50°C above room temperature. The appliances electrical safety can only be guaranteed when it has been correctly connected to a properly earthed power supply, as laid down in the regulations for electrical safety.
88min min 550 450 860 min 566 20 597 580min Building under 22 min 550 50 4 11 540 895 100 min 550 50 4 Fig. 2 Important The housing should not be free standing, but secured to the wall or/and adjacent fittings and housing, do not lift it by the door handle. Do not force the oven into the housing using the open door as a lev and never exercise excessive pressure on the open door. The oven should be secured to the housing by nº 4 fitting screws in holes of the frame as shown in fig. 3. Fig.
XGB Regulating the gas Adaptation for different types of gas. If the appliance requires a different type of gas than the kind available (see the serial number located near the hinge of the oven door), the injectors must be changed, the minimum adjusted and the air regulated. Grill burner To change the grill injector, it is necessary to act as follows: open the oven door, unscrew screw C and disassemble the grill burner (see fig.D). Change the injector (see fig.
XGB REGULATION OF AIR ADJUSTER (oven burner ) To do this, - To loosen the screw (A ) in order to rotate the metal ring at the end of the burner (fig L ). In this way, entrace of the air increases or descreases, obtaining a correct flame. Be sure that the flame does not lift or light back or present a yellow colouration . Tab. D GENERAL INJECTORS TABLE Power KW Consum. Kind of gas mbar Nozzle Burners N° max. min. max. min.
XGB USE It is important that all the operations related to installation and regulation be carried out by specialised staff in accordance with the norms in force. The specific instructions are described in the chapters for the installer. Before using the appliance, carefully remove the special protective film that protects the stainless steel or anodized aluminium items. The ovens thermal isolation and the grease residue from the work produce smoke and unpleasant odours during the first few minutes of use.
XGB Oven cooking Before use, heat the oven to the desired temperature. Upon reaching the desired temperature, introduce food and check the cooking temperature, taking care to turn it off 5 minutes before the end of the cooking time in order to recover the stored heat. Electric grill To operate the electric grill, turn the knob in position (fig. 6D) and turn the thermostat control knob (fig 6C) to the 200°C . The grill must be used with the oven door closed.
XGB Oven door removal and refitting Open fully the oven door and hook the ring A to the upper bar of the door hinge as shown in the fig. 10. Once hinge locked, grip both sides of the door, near the hinges, then lift and remove as in the fig. 11. After cleaning refit the oven door inversely proceeding in similar way. Make sure the lower bars of the hinges correctely placed in the proper slots and the rings A released from the upper bars before closing the door. Grill Cooking The heat comes from above.
