User manual
In daily use18
3 If you want to use 3 in 1 detergents, check whether these detergents are suita
ble for your water hardness. (Follow manufacturer’s instructions!)
If your water hardness is higher than that recommended by the manufacturer
but you would nevertheless like to use 3 in 1 detergent, proceed as follows:
• With the 3 in 1 function selected, set the water softener one hardness setting
lower than when rinsing without 3 in 1 detergent.
• Fill up the dispenser (if this is empty) with special salt.
The dishwasher remembers the two different settings of the degree of hardness
for rinsing with and without 3 in 1 function.
If you want to use 3 in 1 products
1. Press the ON/OFF button.
2. Press the 3IN1 button.
The button indicator lights up: 3in1 function is selected.
Before the start of the dishwashing cycle put 3in1 detergent in the detergent
dispenser.
3 As the rinse aid inflow is automatically switched off when the 3 in 1 function is
activated, it may come about because of the different quality standards in the 3
in 1 detergent, that the dishes do not dry sufficiently.
If this happens, proceed as follows (see section “Adding rinse aid”):
• Fill up the dispenser (if this is empty) with rinse aid.
• Set rinse aid dosage to “2” mechanically.
• Activate rinse aid inflow.
If you do not want to use 3 in 1 products any more
If you want to stop using 3 in 1 products, please do the following:
• Deactivate the 3 in 1 function.
• Fill up the dispensers for salt and rinse aid again.
• Switch the water softener to the highest setting and perform up to three nor
mal cycles without loading any dishes.
• Then set the water softener to the water hardness in your area.
If you want to use 4 in 1 products
When using "4 in 1" detergents that integrate also anti glass corrosion agent
into "3 in 1" formula, please follow the same indication as given for "3 in 1" de
tergents.