User manual
Installing the Dishwasher31
Installing the Dishwasher
• The dishwasher must be installed on a firm floor and adjusted to ensure that it
is stable and level in all directions.
• To compensate for unevenness in the floor and to match the height of the ap
pliance to that of surrounding units, extend the threaded feet using a screw
driver.
• Adjust the rear foot of the appliance using a cordless screwdriver from the
front of the appliance (see installation template).
• The drain hose, inlet hose and mains cable must be laid so that they are able to
move freely within the plinth area, and so that they are not kinked or crushed
when the dishwasher is in position.
• The dishwasher must also be screwed tightly to the work surface or to the ad
joining units. This is essential to ensure the dishwasher does not tip up.
Dishwashers That Can be Integrated
(see installation template supplied)
Using the installation template supplied, split cupboard doors can be easily in
stalled and firmly fitted.
Connecting the dishwasher
Connecting to the water supply
• The dishwasher can be connected to cold or hot water supplies up to max.
60°C.
• The dishwasher must not be connected to open hot water appliances or in
stantaneous water heaters.
Permitted water pressure
Lowest permitted water pressure:
0,1 MPa ( = 1 bar = 10 N/cm
2
)
Consult your plumber if the water pressure is
less than 0,1 MPa
Highest permitted water pressure:
1 MPa ( = 10 bar = 100 N/cm
2
)
If the water pressure is greater than
1 MPa, a pressure reduction valve must be used
(available from your dealer).