User manual

Operating instructions
34
What to do, when...
Certain problems are due to the lack of simple maintenance or
oversights, which can be solved with the help of the instructions given
here, without calling out an engineer.
...a flashing fault code appears
The dishwasher will not start or stops during operation.
The intervention of an alarm is indicated by:
- the continuous flashing of the indicator light of the running
programme,
- a fault code is visible in the digital display (as described in the chart).
Open the door and carry out the following suggested corrective
actions.
Fault code / Malfunction
-in the digital display
appears
The machine does not fill
with water
The water tap is blocked or
furred with limescale.
The water tap is turned off.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked.
Clean out the sink spigot.The sink spigot is blocked.
Check the water drain
hose connection.
Clean the water tap.
Turn the water tap on.
Clean the filter in the
threaded hose fitting.
The water inlet hose has not
been correctly laid or it is
bent or squashed.
Check the water inlet hose
connection.
The water drain hose has not
been correctly laid or it is
bent or squashed.
Possible cause Solutions
-in the digital display
appears
The dishwasher will not
drain
Close the water tap and
contact your local Service
Force Centre.
Anti-flood device is activated.
-in the digital display
appears
Once the checks have been carried out, close the door and press the
button of the programme that was running before the intervention of
the alarm, the programme will continue from the point at which it was
interrupted. If the fault code reappears contact your local Service
Force Centre.
For other combinations of fault codes not described in the above chart
will appear, please contact your local Service Force Centre.
152955 84/0en 4-04-2005 14:39 Pagina 34