Favorit 65411 VI User manual Dishwasher
Contents Thank you for choosing one of our high-quality products. To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. And please pass it to any future owner of the appliance. We wish you much joy with your new appliance.
Safety information 3 Operating instructions Safety information For your safety and correct operation of the appliance, read this manual carefully before installation and use. Always keep these instructions with the appliance even if you move or sell it. Users must fully know the operation and safety features of the appliance. Correct use • Only use the appliance to clean household utensils that are suitable for dishwashers. • Do not put solvents in the appliance. Risk of explosion.
Safety information Installation • Make sure that the appliance is not damaged because of transport. Do not connect a damaged appliance. If necessary, contact the supplier. • Remove all packaging before first use. • A qualified and competent person must do the electrical installation. • A qualified and competent person must do the plumbing installation. • Do not change the specifications or modify this product. Risk of injury and damage to the appliance.
Product description 5 Product description 1 2 3 4 5 6 7 8 9 Upper basket Water hardness dial Salt container Detergent dispenser Rinse aid dispenser Rating plate Filters Lower spray arm Upper spray arm Light beam After the start of the washing program, a light beam shows on the floor below the appliance door. If the appliance is installed higher with a flush kitchen furniture door, the light beam will not be visible. Light beam The red light is on. Indication of the start of a washing program.
Control panel Control panel 7 1 2 3 4 5 6 7 On/off button Digital display Delay start button Program selection buttons Indicator lights Program indicator lights Function buttons Indicator lights MULTITAB The indicator light shows the activation/deactivation of the multitab function. Refer to 'Multitab function'. 1) The indicator light comes on when it is necessary to fill the salt container. Refer to 'Use of dishwasher salt'.
Control panel • • • • • 7 remaining time to the end of the program, end of a washing program, number of hours in delay start, fault codes, deactivation/activation of the audible signals. Delay start button Use the delay start button to delay the start of the washing program with an interval between 1 and 19 hours. Refer to 'Select and start a washing program'. Function buttons Use the function buttons for these operations: • to set the water softener. Refer to 'Setting the water softener'.
Use of the appliance Audible signals activated The audible signals are activated. 5. Press the function button C again. – The digital display shows the new setting. The audible signals are deactivated. 6. Switch off the appliance to save the operation. Do these steps to activate the audible signals: 1. Do the above procedure until the digital display shows necessary setting. Use of the appliance Refer to specified instructions for each step of the procedure. 1.
Use of dishwasher salt Water hardness 9 Water hardness setting mg/l ppm mmol/l manually electronically 70 - 189 70 - 189 0,7 - 1,8 1 2 < 70 < 70 < 0,7 1 11) 1) No use of salt required. You must set the water softener manually and electronically. Manual adjustment The appliance is set at the factory at position 2. 1. Open the door. 2. Remove the lower basket. 3. Turn the water hardness dial to position 1 or 2 (refer to the chart). 4. Install the lower basket. 5. Close the door.
Use of rinse aid CAUTION! Grains of salt and salty water on the bottom of the appliance can cause corrosion. Fill the appliance with salt before you start a washing program to prevent corrosion. Do these steps to fill the salt container: 1. Turn the cap anticlockwise to open the salt container. 2. Fill the salt container with 1 litre of water (only the first operation). 3. Use the funnel to fill the salt container with salt. 4. Remove the salt around the opening of the salt container. 5.
Use of rinse aid 11 1. Press the release button (A) to open the rinse aid dispenser. 2. Fill the rinse aid dispenser with rinse aid. The mark 'max.' shows the maximum level. 3. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam during the subsequent washing program. 4. Close the rinse aid dispenser. Adjusting the rinse aid dosage The rinse aid is set at the factory at position 4.
Loading cutlery and dishes Loading cutlery and dishes Helpful hints and tips CAUTION! Only use the appliance for household utensils that are suitable for dishwashers. Do not use the appliance to clean objects that can absorb water (sponges, household cloths, etc.). • Before you load cutlery and dishes, do these steps: – Remove all food remainings and debris. – Make burnt, remaining food in pans soft. • While you load cutlery and dishes, do these steps: – Load hollow items (e.g.
Loading cutlery and dishes 13 The rows of prongs in the lower basket can be adjusted flat to load pots, pans and bowls. Cutlery basket WARNING! Do not put long-bladed knives in a vertical position. Arrange long and sharp cutlery horizontally in the upper basket. Be careful with sharp items. Put forks and spoons with the handles down. Put knives with the handles up. If the points of the knives or other thin items come out from the bottom of the basket, they can prevent the rotation of the lower spray arm.
Loading cutlery and dishes Use the cutlery grids for best washing results. If the dimensions of the cutlery prevent use of the cutlery grids, you can fold them out. You can open the cutlery basket to remove the cutlery more easily. Follow these steps to remove the cutlery. 1. Put the cutlery basket on a table or work surface. 2. Open the handle. 3. Remove the cutlery. Hold the two parts of the handle tightly when you move the cutlery basket.
Use of detergent 15 • For longer items fold the cup racks up. Adjustment of the height of the upper basket If you put large plates in the lower basket, first move the upper basket to a upper position. Maximum height of the dishes in: the upper basket the lower basket Upper position 20 cm 31 cm Lower position 24 cm 27 cm Follow these steps to move the upper basket to the upper position: 1. Pull the basket out until it stops. 2.
Use of detergent 1. Open the lid of the detergent dispenser. 2. Fill the detergent dispenser (A) with detergent. The marking shows the dosage: 20 = approximately 20 g of detergent 30 = approximately 30 g of detergent. 3. If you use a washing program with prewash, put more detergent in the prewash detergent compartment (B). A B 4. If you use detergent tablets, put the detergent tablet in the detergent dispenser (A) . 5. Close the lid of the detergent dispenser.
Multitab function 17 Multitab function The multitab function is for combi detergent tablets. These tablets contain agents such as detergent, rinse aid and dishwasher salt. Some types of tablets can contain other agents. Do a check if these tablets are suitable for the local water hardness. Refer to the instructions from the manufacturer. The multitab function can be set with any program. When you set the multitab function, it stays on until you deactivate it.
Select and start a washing program To use normal detergent again: 1. Deactivate the multitab function. 2. Fill the salt container and rinse aid dispenser. 3. Adjust the water hardness setting to the highest level. 4. Do a washing program without dishes. 5. Adjust the water softener to the water hardness in your area. 6. Adjust the rinse aid dosage. Select and start a washing program Set the washing program with the door ajar. The washing program only starts after you close the door.
Select and start a washing program 19 WARNING! Only interrupt or cancel a washing program if necessary. Attention! Open the door carefully. Hot steam and water can escape. Interrupting a washing program Open the door. • The program stops. Close the door. • The program continues from the point of interruption. Cancelling a washing program 1. Press and hold function buttons B and C until all the program lights come on. 2. Release function buttons B and C to cancel the washing program.
Washing programs Washing programs Washing programs Program Degree of soil Type of load Program description Heavy soil Crockery, cutlery, pots and pans Prewash Main wash up to 70°C 2 intermediate rinses Final rinse Drying AUTO-MATIC 2) Any Crockery, cutlery, pots and pans Prewash Main wash up to 50°C or 65°C 1 or 2 intermediate rinses Final rinse Drying 30 MIN 3) Normal or light soil Crockery and cutlery Main wash up to 60°C Final rinse ECO 50° 4) Normal soil Prewash Main wash up to 50°C
Washing programs 21
Care and cleaning Care and cleaning WARNING! Switch the appliance off before you clean it. Cleaning the filters CAUTION! Do not use the appliance without the filters. Make sure that the installation of the filters is correct. Incorrect installation will cause unsatisfactory washing results and damage to the appliance. If necessary, clean the filters. Dirty filters decrease the washing results. The dishwasher has three filters: 1. coarse filter (A) 2. microfilter (B) A 3.
What to do if… 23 13. Install the lower basket. 14. Close the door. Do not remove the spray arms. If the holes in the spray arms become clogged, remove remaining parts of soil with a cocktail stick. External cleaning Clean the external surfaces of the appliance and control panel with a damp soft cloth. Only use neutral detergents. Do not use abrasive products, scouring pads or solvents (acetone, trichloroethylene etc.). Internal cleaning Do an inspection at intervals of 3 months.
What to do if… Fault code and malfunction Possible cause and solution • intermittent audible signal, • The water tap is blocked or restricted with limescale. • the digital display shows Clean the water tap. The appliance does not fill with wa- • The water tap is closed. ter Open the water tap. • The filter in the water inlet hose is blocked. Clean the filter. • The installation of the water inlet hose is not correct. The hose can be kinked or squashed. Make sure that the installation is correct.
Technical data 25 The cleaning results are not satisfactory The dishes are not clean • The selected washing program is not applicable for the type of load and soil. • The baskets are loaded incorrectly so that water cannot reach all surfaces. • Spray arms do not turn freely because of incorrect arrangement of the load. • The filters are dirty or not correctly installed. • The quantity of detergent is too little or missing. Limescales particles on the dishes • The salt container is empty.
Installation Installation instructions Installation There should be a minimum 2mm gap between the top of the dishwasher and underside of bench top The hose s hould not be extended by more than 2 metres or water pumpout problems ma y occu r Fix drain hose max of 10mm below the top of the dishwashe r Remove entire plastic membrane from sink trap spigot & fit drain hose to spigot with clamp Secure dishwasher with brackets and screws provided 600mm max. 300mm min.
Installation 27 Make sure that the water inlet hose, the drain hose and the mains cable are not kinked or squashed, when you insert the appliance. Adjust the level of the appliance Make sure that the appliance is level to close and seal the door correctly. If the level of the appliance is correct, the door does not catch on the sides of the cabinet. Loosen or tighten the adjustable feet until the appliance is level.
Water connection 2. Use the supplied screws to secure the appliance in position (upwards or sideways). Make sure the screws are tightened. Custom made kick-panel For integrated appliances and full-stainless-steel door appliances. We recommend that you make a custom made kick-panel that aligns your kitchen cabinets. • A notched continuous panel is necessary to prevent door swing interference and to keep kickpanel alignment with adjacent units.
Water connection 29 Make sure that there are no kinks in the water inlet hose and that the water inlet hose is not squashed or entangled. Fit the hose nut correctly to prevent water leaks. CAUTION! Do not connect the appliance to new pipes or pipes that have been not used for a long time. Let the water run for some minutes, then connect the inlet hose. The water inlet hose is double-walled and has an inner mains cable and a safety valve.
Electrical connection If you connect the water drain hose to a trap spigot under the sink, remove the plastic membrane. If you do not remove the membrane, remaining food can cause a blockage in the drain hose spigot The appliance has a security feature to prevent dirty water going back into the appliance. If, the spigot of the sink has a 'non-return valve', this valve can cause the appliance to drain incorrectly. Remove the non-return valve.
Environment concerns 31 Environment concerns The packaging materials are environmentally friendly and can be recycled. The plastic components are identified by markings, e.g. >PE<, >PS<, etc. Discard the packaging materials in the applicable container at the community waste disposal facilities. WARNING! To discard the appliance, follow the procedure: • Pull the mains plug out of the socket. • Cut off the mains cable and mains plug and discard them. • Discard the door catch.
Warranty 2. This warranty only applies to Appliances purchased and used in Australia or New Zealand and is in addition to (and does not exclude, restrict, or modify in any way) any non-excludable statutory warranties in Australia or New Zealand. 3. Electrolux warrants that, when dispatched from an Electrolux warehouse, the Appliance is free from defects in materials and workmanship for the Warranty Period. 4.
11. Provisions of the Trade Practices Act and State consumer legislation in Australia, and the Consumer Guarantees Act, the Sale of Goods Act and the Fair Trading Act in New Zealand, imply warranties or conditions, or impose obligations, upon Electrolux which cannot be excluded, restricted or modified.
www.electrolux.com 117960260 - 00 - 102008 www.aeg-electrolux.com.
