User Guide

29
What to do, when...
Try to rectify minor faults on the dishwasher with the aid of the instructions
given here.
...a flashing fault code appears
an audible signal informs you that an alarm has been activated, one or more
indicator lights of the phases is/are flashing.
They are indicative of a fault in the dishwasher that you can probably rectify
yourself.
- press the On/Off pushbutton to switch the dishwasher off
- open the door and carry out the following suggested corrective actions.
Fault code
"Prewash/Rinse and Hold"
and ""Rinse" phase
indicator lights
are flashing
"Wash" and "Rinse"
phase indicator lights
are flashing
"Rinse" phase indicator
light is flashing
Other phase indicator
lights are flashing
The water tap is closed. Open the water tap.
The mains water supply has
been cut off.
The inlet hose may be
squashed or bent.
The inlet hose may be
blocked.
The drain hose may be
squashed or bent. The drain
hose extension is not
correct.
The sink may be blocked.
Protection against flooding
is active.
General
Close the water tap and
contact the Service
Centre.
Open the door, switch off
the dishwasher, switch
back on and start a wash
programme.
Clear any blockages.
Reposition correctly the
drain hose. Follow the
instructions for
connecting to the waste.
Switch off the water
supply and clean the filter.
Reposition correctly the
hose.
Possible cause Remedy
Once checked the possible causes listed above, switch on the dishwasher and
start a wash programme, if the fault code reappears contact the Service
Centre.
152985 61/2 en-es 30-11-1999 16:15 Pagina 29