User manual

16
Cleaning and care
1
Take care! Risk of burns from residual heat.
1 Important Sharp objects and abrasive cleaning materials will damage
the appliance. Clean with water and washing up liquid.
1 Important Residues from cleaning agents will damage the appliance.
Remove residues with water and washing up liquid.
Cleaning the appliance after each use
1. Wipe the appliance with a damp cloth and a little washing up liquid.
2. Rub the appliance dry using a clean cloth.
Removing deposits
1. Place the scraper on the glass ceramic surface at an angle.
2. Remove residues by sliding the blade over the surface.
3. Wipe the appliance with a damp cloth and a little washing up liquid.
4. Rub the appliance dry using a clean cloth.
*Scrapers and cleaners for glass ceramic and stainless steel can be purchased in specialist shops,
supermarkets, the parts department of your local Service Force Centre or from
www.shop.electrolux.co.uk
3 Remove stubborn residues with a cleaner for glass ceramic or stainless steel.
3 Scratches or dark stains on the glass ceramic that cannot be removed
do not however affect the functioning of the appliance.
Removable Frontline strip
The aluminium Frontline strip fastens on by means of magnets. It is
easy to remove by hand and can be cleaned with detergent. Please do
not use any scouring agents or sponges that scratch. Do not clean the
strip in the dishwasher.
Remove
Type of dirt
imme-
diately
when the appliance has
cooled down
using
sugar, food containing sugar yes ---
a scraper*
plastics, tin foil yes ---
limescale and water rings --- yes
cleaner for glass ce-
ramic or stainless
steel*
fat splashes --- yes
shiny metallic discolorations --- yes
17
What to do if …
If you are unable to remedy the problem by following the above
suggestions, please contact your local Service Force Centre.
1 Warning! Repairs to the appliance are only to be carried out by quali-
fied service engineers. Considerable danger to the user may result from
improper repairs.
Problem Possible cause Remedy
The cooking zones will not
switch on or are not func-
tioning
More than 10 seconds have
passed since the appliance
was switched on
Switch the appliance on
again.
The child safety device is
switched on l
Deactivate the child safety
device (See the section
“Child safety device”)
Several sensor fields were
touched at the same time
Only touch one sensor field
The sensor fields are partly
covered by a damp cloth or
with liquid
Remove the cloth or the
liquid.
Switch the appliance on
again.
Safety cut-out has been
triggered
Switch the appliance on
again
STOP+GO is activated u Switching off STOP+GO
The residual heat indicator
is not displaying anything
The cooking zone was only
on for a short time and is
therefore not hot
If the cooking zone is sup-
posed to be hot, call your
local Service Force Centre.
The automatic warm-up
function is not switching
itself on
The highest heat setting is
set
Ç
The highest heat setting
has the same power as the
automatic warm-up func-
tion
e and number are dis-
played
Electronics fault Disconnect the appliance
from the electrical supply
for a few minutes (Take the
fuse out of the house’s wir-
ing system)
If after switching on again,
e is displayed again, call
the customer service de-
partment