User manual

26
8. Place Frontline strips on the appliances. Check that the Frontline strips
are in line with one another.
9. Tighten the fixing plate / retaining grip screws.
10. Inject a line of silicon into the gap between the appliances.
11. Dampen silicon line with a little soapy water.
12. Press rubber block hard against the glass ceramic and draw it slowly
along the gap.
13. Leave silicon until the next day to harden.
14. Carefully remove projecting silicon with a shaving blade.
15. Clean glass ceramic thoroughly.
16. Replace Frontline strips.
7
Control panel layout
Left-hand side
Right-hand side
STOP+GO
pilot light
Heat setting
indicator
Warm up
pilot light
Warm up
pilot light
Double ring
pilot light
Heat setting
indicator
STOP+GO
Heat setting se-
lection
Automatic
warm-up
function
Automatic warm-up
function
Outer ring
On/Off
Heat setting
selection
Heat setting
indicator
Warm up pi-
lot light
Double ring
pilot light
Heat setting
indicator
On/Off pi-
lot light
Heat setting
selection
Automatic
warm-up
Automatic warm-
up function
Outer ring
On/Off
Heat setting
selection
On/Off
Warm up
pilot light