User manual

24
Installing more than one Frontline hob
Additional parts: cross bar(s), heat resistant silicon, rubber block, shav-
ing blade.
3 Only use special heat-resistant silicon.
Cut-out section
Distance from the wall: at least 50 mm
Depth:490 mm
Width: The widths of all appliances to be built-in are added together,
minus 20 mm (see also “Overview of all appliance widths”)
Example:
Installing more than one appliance
1. Work out the size of the cut-out section and saw it out.
2. Remove Frontline strip from the appliances by hand (magnetic fasten-
ing).
3. Lay the appliances one at a time on something soft (for example a
blanket) with the underside facing upwards.
4. Screw / clip fixing plates / retaining grips into the appropriate holes in
the protective boxes.
9
Residual heat indicator
1 Warning! Risk of burns from residual heat. After being switched off,
the cooking zones need some time to cool down. Look at the residual
heat indicator
h .
3 Residual heat can be used for melting and keeping food warm.
Operating the appliance
Switching the appliance on and off
3 After switching on, within approx. 10 seconds a heat setting or a func-
tion must be set, otherwise the appliance automatically switches itself
off.
3 Switching off also works by touching and at the same time. This
applies for all individual functions, for example, ”Switching off the
Timer”.
Selecting the heat setting
Control panel Display Pilot light
Switch on Touch for 2 seconds ¾ / h lights up
Switch off Touch for 1 second h / none goes out
Control panel Indicator
To increase Touch u to Ç
To decrease Touch Ç to ¾
To switch off Touch and at the same time ¾